User manual WEED EATER PE550

[. . . ] ENGLISH R Trademark Please do not return unit to retailer. Por favor, no devuelva el aparato al lugar de compra. Veuillez ne pas retourner l'outil au détaillant. 1-800-554-6723 www. weedeater. com Instruction Manual Manual de Instrucciones Manuel d'Instructions ESPAÑOL PE550 WARNING: Read and follow all Safety Rules and Operating Instructions before using this product. Failure to do so can result in serious injury. [. . . ] Mix gasoline and oil at a ratio of 40:1 (A 40:1 ratio is obtained by mixing 3. 2 ounces of oil with 1 gallon of unleaded gasoline). When mixing fuel, follow instructions printed on container. Once oil is added to gasoline, shake container momentarily to assure that the fuel is thoroughly mixed. Always read and follow the safety rules relating to fuel before fueling your unit. S Assemble handle tube to the lower tube (it will be necessary to pull some of the starter rope out of the housing). S Align the screw holes; insert the screws through the aligned holes. S Thread one locknut onto each screw and tighten securely. STARTING STOPPING YOUR ENGINE S To stop a running engine, move the switch to the OFF position. S If engine does not stop, move choke lever to FULL CHOKE position. ON/OFF Switch Handle tube Screws Lower Tube Starter Rope STARTING YOUR ENGINE Locknuts DANGER: The cutting blade will turn when the engine starts. WARNING: Avoid any contact with the muffler. Support the unit so the blade is off of the ground and away from trees, bushes, onlookers, etc. NOTE: When performing the following step, be sure the starter rope is not caught under the cable clamp. The starter rope must hang freely to operate properly. S Align the cable clamp between the tube screws. Install the cable clamp around the tube and throttle cable. 4 STARTING POSITION S Make sure switch is in ON position. S Move choke lever to FULL CHOKE position. Choke Lever FULL HALF OFF S Squeeze and hold the throttle trigger. Keep throttle trigger fully squeezed until the engine runs smoothly. STARTING A COLD ENGINE OR A WARM ENGINE AFTER RUNNING OUT OF FUEL S Make sure switch is in ON position. S Move the choke lever to the HALF CHOKE position. S Squeeze and hold the throttle trigger. Keep throttle trigger fully squeezed until the engine runs smoothly. S Pull starter rope sharply until engine runs, but no more than 5 pulls. S Allow engine to run 10 seconds, then move the choke lever to OFF CHOKE position. NOTE: If engine has not started, pull starter rope 5 more pulls. [. . . ] Expenses covered under warranty include diagnosis, parts and labor. MANUFACTURER'S WARRANTY COVERAGE: If any emissions related part on your engine (as listed under Emissions Control Warranty Parts List) is defective or a defect in the materials or workmanship of the engine causes the failure of such an emission related part, the part will be repaired or replaced by POULAN/ WEED EATER. OWNER'S WARRANTY RESPONSIBILITIES: As the lawn and garden equipment engine owner, you are responsible for the performance of the required maintenance listed in your instruction manual. POULAN/WEED EATER recommends that you retain all receipts covering maintenance on your lawn and garden equipment engine, but POULAN/WEED EATER cannot deny warranty solely for the lack of receipts or for your failure to ensure the performance of all scheduled maintenance. [. . . ]