User manual WEED EATER RT112

[. . . ] ENGLISH R Trademark Please do not return unit to retailer. Por favor, no devuelva el aparato al lugar de compra. Veuillez ne pas retourner l'outil au détaillant. 1-800-554-6723 www. weedeater. com Instruction Manual Manual de Instrucciones Manuel d'Instructions ESPAÑOL RT110 RT112 WARNING: Read and follow all Safety Rules and Operating Instructions before using this product. Read instructions carefully before assembling. [. . . ] S Store unit indoors in a high, dry place out of the reach of children. S Do not hang unit so that the trigger switch is depressed. UNIT SAFETY S Inspect unit before use. Make sure all handles, guards, and fasteners are in place and securely fastened. Parts that are damaged must be repaired or replaced by an authorized service dealer These include head parts that are cracked, or chipped, guards, and any other part that is damaged. (1. 65 mm) diameter recommended trimmer line (see USER REPLACEABLE SERVICE PARTS in the SERVICE AND ADJUSTMENTS section). Make sure spool is properly installed and all parts are securely fastened. S Use only WEED EATER replacement parts and accessories as recommended. DOUBLE INSULATION CONSTRUCTION CUTTING SAFETY WARNING: Inspect area to be cut. Remove objects (rocks, broken glass, nails, wire, string, etc. ) which can be thrown or become entangled in cutting head. S Do not overreach or stand on unstable support. S Keep the cutting head below waist level. Cutting head can come dangerously close to your body. S Keep away from cutting head and spinning line. Use only for trimming, scalping, and mowing. It will do the job better and with less risk of injury at the rate for which it was designed. S Use only in daylight or in good artificial light. This unit is double insulated to help protect against electric shock. Double insulation construction consists of two separate "layers" of electrical insulation instead of grounding. Tools built with this insulation system are not intended to be grounded. No grounding means is provided on this unit, nor should a means of grounding be added to this unit. As a result, the extension cord used with your unit can be plugged into any standard 120 volt electrical outlet. Safety precautions must be observed when operating any electrical tool. The double insulation system only provides added protection against injury resulting from an internal electrical insulation failure. WARNING: All electrical repairs to this unit, including housing, switch, motor, etc. , must be diagnosed and repaired by qualified service personnel. Replacement parts for a double insulated appliance must be recommended by the manufacturer. [. . . ] Align the notch with the line exit hole. Push the spool into the hub until it snaps into place. USER REPLACEABLE SERVICE PARTS REPLACEMENT PART Spool with 0. 065 Trimmer Line Assist Handle Bolt Carriage, 1/4-20 Wing Nut Shield Assembly (RT110) Shield Assembly (RT112) Hub Line exit hole PART NUMBER 952701663 530403805 530403886 530016152 530404080 530404076 7 STORAGE steps after each use. S Stop the unit and disconnect the power source when not in use. S Store the unit so the line limiter blade cannot cause injury. WARNING: Perform the following S Store unit and extension cord indoors in a S Store unit with all guards in place. [. . . ]