User manual WEED EATER RT112C

[. . . ] ENGLISH R Trademark Please do not return unit to retailer. Por favor, no devuelva el aparato al lugar de compra. Veuillez ne pas retourner l'outil au détaillant. 1-800-554-6723 www. weedeater. com Instruction Manual Manual de Instrucciones Manuel d'Instructions ESPAÑOL RT112C WARNING: Read and follow all Safety Rules and Operating Instructions before using this product. Read instructions carefully before assembling. [. . . ] S Use only 0. 065 inch (1. 65 mm) diameter recommended trimmer line (see USER REPLACEABLE SERVICE PARTS in the SERVICE AND ADJUSTMENTS section). Make sure spool is properly installed and all parts are securely fastened. S Use only WEED EATER replacement parts and accessories as recommended. DOUBLE INSULATION CONSTRUCTION CUTTING SAFETY WARNING: Inspect area to be cut. Remove objects (rocks, broken glass, nails, wire, string, etc. ) which can be thrown or become entangled in cutting head. S Do not overreach or stand on unstable support. S Keep the cutting head below waist level. Cutting head can come dangerously close to your body. S Keep away from cutting head and spinning line. Use only for trimming, scalping, and mowing. It will do the job better and with less risk of injury at the rate for which it was designed. S Use only in daylight or in good artificial light. This unit is double insulated to help protect against electric shock. Double insulation construction consists of two separate "layers" of electrical insulation instead of grounding. Tools built with this insulation system are not intended to be grounded. No grounding means is provided on this unit, nor should a means of grounding be added to this unit. As a result, the extension cord used with your unit can be plugged into any standard 120 volt electrical outlet. Safety precautions must be observed when operating any electrical tool. The double insulation system only provides added protection against injury resulting from an internal electrical insulation failure. WARNING: All electrical repairs to this unit, including housing, switch, motor, locking sleeve assembly, wires, etc. , must be diagnosed and repaired by qualified service personnel. Replacement parts for a double insulated appliance must be recommended by the manufacturer. A double insulated appliance is marked with the words "double insulation" or "double insulated". The symbol may also be (square within a square) marked on the appliance. Failure to have the unit repaired by qualified service personnel can cause the double insulation construction to become ineffective and result in serious injury. SAVE THESE INSTRUCTIONS 3 ASSEMBLY WARNING: If received assembled, review all assembly steps to ensure your unit is properly assembled and all fasteners are secure. Upper Locking Sleeve Assembly TUBE ASSEMBLY WARNING: The upper and lower tubes must be snapped together, remain permanently assembled together and the locking sleeve assembly must be fully tightened before and during use to avoid serious injury to the operator and/or damage to the unit. [. . . ] Push the spool into the hub until it snaps into place. Hub Line exit hole 7 USER REPLACEABLE SERVICE PARTS REPLACEMENT PART Spool with 0. 065 Trimmer Line Assist Handle Bolt Carriage, 1/4-20 Wing Nut Shield Assembly PART NUMBER 952701663 530403805 530403886 530016152 530404076 STORAGE steps after each use. S Stop the unit and disconnect the power source when not in use. S Store the unit so the line limiter blade cannot cause injury. WARNING: Perform the following S Store unit and extension cord indoors in a high, dry place out of the reach of children. Position unit so that any sharp object cannot accidentally cause injury. TROUBLESHOOTING TABLE WARNING: Always stop unit and disconnect from the power source before performing all of the recommended remedies below except remedies that require unit to be operating. TROUBLE Trimmer head 1. [. . . ]