User manual WEED EATER RTE115

[. . . ] ENGLISH R Trademark Please do not return unit to retailer. Por favor, no devuelva el aparato al lugar de compra. Veuillez ne pas retourner l'outil au détaillant. 1-800-554-6723 www. weedeater. com Instruction Manual Manual de Instrucciones Manuel d'Instructions ESPAÑOL RTE115 WARNING: Read and follow all Safety Rules and Operating Instructions before using this product. Read instructions carefully before assembling. [. . . ] Double insulation construction consists of two separate "layers" of electrical insulation instead of grounding. Tools built with this insulation system are not intended to be grounded. No grounding means is provided on this unit, nor should a means of grounding be added to this unit. As a result, the extension cord used with your unit can be plugged into any standard 120 volt electrical outlet. Safety precautions must be observed when operating any electrical tool. The double insulation system only provides added protection against injury resulting from an internal electrical insulation failure. S Inspect area to be cut. Remove objects (rocks, broken glass, nails, wire, string, etc. ) which can be thrown or become entangled in cutting head. S Do not overreach or stand on unstable support. S Keep the cutting head below waist level. Cutting head can come dangerously close to your body. S Keep away from cutting head and spinning line. Use only for trimming, edging, scalping, and mowing. It will do the job better and with less risk of injury at the rate for which it was designed. S Use only in daylight or in good artificial light. WARNING: All electrical repairs to this unit, including housing, switch, motor, etc. , must be diagnosed and repaired by qualified service personnel. Replacement parts for a double insulated appliance must be recommended by the manufacturer. A double insulated appliance is marked with the words "double insulation" or "double insulated". The may also symbol (square within a square) be marked on the appliance. Failure to have the unit repaired by qualified service personnel can cause the double insulation construction to become ineffective and result in serious injury. SAVE THESE INSTRUCTIONS MAINTENANCE SAFETY WARNING: Disconnect unit from the power supply before performing maintenance, or when changing trimmer line. 3 ASSEMBLY WARNING: If received assembled, review all assembly steps to ensure your unit is properly assembled and all fasteners are secure. ADJUSTING ASSIST HANDLE 1. Loosen and remove wing nut and bolt from assist handle. Firmly push the assist handle over the tube. [. . . ] Rest guide ring on spool and place line in slot. Allow line to extend 4 - 6 inches (10 15 cm) from center of spool. Ensure line remains in slot while screwing cap on to the shaft. Only tighten cap hand tight! USER REPLACEABLE SERVICE PARTS REPLACEMENT PART Spool with 0. 065 inch Trimmer Line Line Guide Ring Cap Assembly Assist Handle Bolt Carriage, 1/4-20 Wing Nut Shield Assembly Edge Guide PART NUMBER 952711602 530403949 530403810 530403805 530403886 530016152 530403914 530403824 STORAGE Perform the following steps after each use. [. . . ]