User manual WEED EATER TE400 LE

[. . . ] ENGLISH R Trademark Please do not return unit to retailer. Por favor, no devuelva el aparato al lugar de compra. Veuillez ne pas retourner l'outil au détaillant. 1-800-554-6723 www. weedeater. com Instruction Manual Manual de Instrucciones Manuel d'Instructions TWIST- -EDGE t -NTE 400 LE For Occasional Use Only WARNING: Read and follow all Safety Rules and Operating Instructions before using this product. Failure to do so can result in serious injury. [. . . ] Failure to do so is a violation of the law. For normal homeowner use, the muffler and spark arresting screen will not require any ser- vice. After 50 hours of use, we recommend that your muffler be serviced or replaced by your authorized service dealer. ASSEMBLY WARNING: Make sure your unit is properly assembled and all fasteners are secure. ATTACHING THE HANDLE Groove S Assemble handle to the unit as shown; make sure bottom of handle is seated in the groove in the trigger housing. NOTE: Wing nut must be assembled on the side of the unit opposite the operator's position. S Pivot handle to a comfortable position. Tighten handle securely. TRANSPORTING AND STORAGE ATTACHING THE SHIELD WARNING: The shield must be properly installed. The shield provides partial protection from the risk of thrown objects to the operator and others and is equipped with a line limiter blade which cuts excess line to the proper length. The line limiter blade (on underside of shield) is sharp and can cut you. S Pivot shield until bolt passes through hole in bracket. S Securely tighten wing nut onto bolt. Slot Shield Bracket Line Limiter Blade Wing Nut FUEL YOUR UNIT WARNING: Remove fuel cap slowly when refueling. This engine is certified to operate on unleaded gasoline. Gasoline must be mixed with a good quality synthetic 2--cycle air-cooled engine oil designed to be mixed at a ratio of 40:1. Poulan/Weed Eater brand syn3 thetic oil is recommended. (A 40:1 ratio is obtained by mixing 3. 2 ounces of oil with 1 gallon of unleaded gasoline). When mixing fuel follow the instructions printed on the container. Always read and follow the safety rules under FUEL SAFETY. OPERATING POSITION ALWAYS WEAR: Eye Protection STARTING HOW TO STOP YOUR UNIT To stop engine, move ON/OFF switch to the OFF position. Long Pants Heavy Shoes Cut from your right to your left. HOW TO START YOUR UNIT Starting Position ADVANCING THE CUTTING LINE Advance line by tapping the bottom of the cutting head lightly on the ground while engine is running at full speed. A metal blade attached to the shield will cut the line to the proper length. TWIST- -EDGE -N- S Pull the tab toward the engine. S Twist the tube to the edging position; release the tab. Choke lever Trigger Primer Bulb Muffler Tab WARNING: The trimmer head will turn while starting the engine. A hot muffler can cause serious burns. STARTING A COLD ENGINE (or a warm engine after running out of fuel) S S S S S S S S S REPLACING THE LINE Set unit on a flat surface. Move choke lever to FULL CHOKE position. Squeeze the throttle trigger fully and hold through all remaining steps. [. . . ] 2 YEARS- Parts and Labor, when used for household purposes. 90 DAYS - Parts and Labor, when used for commercial, professional, or income producing purposes. 30 DAYS - Parts and Labor, if used for rental purposes. This warranty is not transferable and does not cover damage or liability caused by improper handling, improper maintenance, or the use of accessories and/or attachments not specifically recommended by ELECTROLUX HOME PRODUCTS, INC. , for this tool. [. . . ]