User manual WEED EATER WEF550L

[. . . ] PELIGRO: Lea el manual de instrucciones y siga todas las advertencias e instrucciones de seguridad. El no hacerlo puede resultar en lesiones graves. DANGER: Lire le manuel d'instructions et bien respecter tous les avertissements et toutes les instructions de sécurité. Tout défaut de le faire pourrait entraîner des blessures graves. Electrolux Home Products, Inc. [. . . ] NOTE: Two mounting brackets are included with this attachment. Both brackets are provided to adapt this attachment for use with powerheads that have either a 1 (2. 5 cm) diameter or a 7/8 (2. 2 cm) diameter upper shaft. The correct bracket must be used to ensure that the handlebar is mounted securely to the upper shaft before use. Screw Handlebar Bracket Cover TIGHTEN 2. Mounting Bracket Place the mounting bracket over the upper shaft above the arrow on the safety label. Be sure to use the correct mounting bracket for either the 1 (2. 5 cm) or 7/8 (2. 2 cm) diameter upper shaft. Position one of the bracket covers under the upper shaft and align the mounting bracket and the bracket cover screw holes. Insert two screws into the screw holes. Remove the shaft cap from the brushcutter attachment (if present). Position locking/release button of attachment into guide recess of coupler. Push the attachment into the coupler until the locking/release button snaps into the primary hole. Before using the unit, tighten the knob securely by turning clockwise. 2. 4 3. 2. Place the upper shoulder strap clamp over the upper shaft above the handlebar. Position the lower shoulder strap clamp under the upper shaft and align the upper and lower clamp screw holes (use spacer tabs between upper and lower clamps if necessary to secure clamp, i. e. for 1 diameter upper shaft). 30 inches (76 cm) 5 OPERATION KNOW YOUR BRUSHCUTTER ATTACHMENT READ THIS INSTRUCTION MANUAL AND SAFETY RULES BEFORE OPERATING YOUR BRUSHCUTTER ATTACHMENT. Compare the illustrations with your unit to familiarize yourself with the location of various controls and adjustments. Save this manual for future reference. Shaft Hanger Gearbox Blade Shield Blade BLADE The BLADE is designed for cutting grass, weeds, and brush up to 1/2 inch in diameter. BLADE SHIELD The BLADE SHIELD provides protection from the spinning blade. Press and hold the locking/release button. Locking/Release Button OPERATING THE COUPLER Your powerhead is equipped with a coupler which enables optional attachments to be installed. The optional attachments are: MODEL: Edger . The blade will have maximum cutting power and is less likely to bind or stall. S "Feed" the blade deliberately and not too rapidly. The blade can thrust away if it is fed too rapidly. [. . . ] While holding the screwdriver in position, remove blade nut by turning clockwise as you are facing the nut. Cupped Washer Threaded Shaft Blade Nut 8 6. Place the cupped washer onto the shaft. Make sure the cupped side of the washer is toward the blade. Install blade nut by threading onto the shaft counterclockwise as you are facing the nut. [. . . ]