User manual WEED EATER WER500H

[. . . ] ADVERTENCIA: Lea el manual de instrucciones y siga todas las advertencias e instrucciones de seguridad. El no hacerlo puede resultar en lesiones graves. AVERTISSEMENT: Veuillez lire le manuel d'instructions et bien respecter tous les avertissements et toutes les instructions de sécurité. Tout défaut de le faire pourrait entraîner des blessures graves. Electrolux Home Products, Inc. [. . . ] Maintain the unit according to recommended procedures. Use only for jobs explained in this manual. BLOWER SAFETY D Use only in daylight or in good artificial light. D Inspect the area before using the unit. Remove all debris and hard objects such as rocks, glass, wire, etc. , that can ricochet, be thrown, or otherwise cause injury or damage during operation. Be sure the switch is in the OFF position and keep your hand and fingers away from the switch while connecting the unit to the power source or when carrying a unit connected to the power source. D Never run the unit without the proper equipment attached. When used as a blower, always install a blower tube. Do not use with any opening blocked, Keep free from dust, lint, hair and anything that may reduce air flow. D To avoid spreading fire, do not use blower near leaf or brush fires, fireplaces, barbecue pits, ashtrays, etc. D Never place objects inside the blower tubes; always direct the blowing debris away from people, animals, glass, and solid objects such as trees, automobiles, walls, etc. The force of air can cause rocks, dirt, or sticks to be thrown or to ricochet which can hurt people or animals, break glass, or cause other damage. The motor must be stopped and the impeller blades no longer turning to avoid serious injury from the rotating blades. 4 WARNING: If you receive your unit assembled, check each step to insure your unit is properly assembled and all fasteners are secure. Follow all safety information in the manual and on unit. S A standard screwdriver is required for assembly. BLOWER ASSEMBLY S Insert the blower tube into the blower outlet. S Twist the blower tube clockwise until it is firmly seated in the blower outlet. S Twist the nozzle into the end of the blower tube until it is firmly seated. Make sure the nozzle points upward. Blower outlet Blower Tube Nozzle ATTACH VACUUM TUBES S On some units an arrow on the tube and the unit will help you align the tube before twisting clockwise. These tabs guide and lock the tubes into position. Once the upper tube is secure on the unit, and cannot be turned clockwise further, the lower vacuum tube may be installed onto the upper tube. Not all unit will have arrows Arrow Arrow For Model 2695 only, the blower extension tube and nozzle are combined into one component. Blower Tube/Nozzle VACUUM ASSEMBLY (Some models) OPEN THE LATCH Insert a screwdriver in to the latch area on the vacuum inlet cover. Gently tilt handle of screwdriver toward the front of the blower to release the latch. Pull up on the vacuum inlet cover with your other hand. Impeller Latch Area Upper Lower tube tube ATTACH VACUUM BAG Slide the vacuum bag over the blower outlet as shown. [. . . ] The inlet cover must be held open through all remaining steps. S Carefully reach into the vacuum opening and clear out the air intake area. If cracked or damaged, do not use the unit. Have parts replaced by your authorized service dealer. [. . . ]