User manual WEED EATER XT300

[. . . ] ENGLISH R Trademark Please do not return unit to retailer. Por favor, no devuelva el aparato al lugar de compra. Veuillez ne pas retourner l'outil au détaillant. 1-800-554-6723 www. weedeater. com Operator's Manual Manual del Operador Manuel de L'utilisateur XT 300 t IMPORTANT MANUAL - Do not throw away MANUAL IMPORTANTE - No lo descarte MANUEL IMPORTANT - À Conserver WARNING: Read and follow all Safety Rules and Operating Instructions before using this product. Failure to do so can result in serious injury. [. . . ] Failure to do so is a violation of the law. If a spark arrestor is required in your area, contact your Authorized Service Dealer for the proper kit. cuts excess line. The blade (on underside of shield) is sharp and can cut you. S Pivot shield until bolt passes through hole in bracket. Slot Shield Bracket SPECIAL NOTICE: This unit is not Wing Nut FUEL YOUR UNIT This engine is certified to operate on unleaded gasoline. Gasoline must be mixed with a good quality 2-cycle air-cooled engine oil designed to be mixed at a ratio of 40:1. Poulan/Weed Eater brand oil is recommended. (A 40:1 ratio is obtained by mixing 3. 2 ounces of oil with 1 gallon of unleaded gasoline). When mixing fuel follow the instructions printed on the container. Always read and follow the safety rules under FUEL SAFETY. SPECIAL NOTICE: Exposure to vibra- tions through prolonged use of gasoline powered hand tools could cause blood vessel or nerve damage in the fingers, hands, and joints of people prone to circulation disorders or abnormal swellings. Prolonged use in cold weather has been linked to blood vessel damage in otherwise healthy people. If symptoms occur such as numbness, pain, loss of strength, change in skin color or texture, or loss of feeling in the fingers, hands, or joints, discontinue the use of this tool and seek medical attention. An anti-vibration system does not guarantee the avoidance of these problems. Users who operate power tools on a continual and regular basis must monitor closely their physical condition and the condition of this tool. STARTING Starting Position ASSEMBLY WARNING: Make sure unit is properly assembled and all fasteners are secure. ADJUST THE HANDLE S Loosen wing nut or plastic knob on handle. S Rotate handle to upright position and tighten in a comfortable position between the trigger and the safety label on the tube. Tighten handle securely. HOW TO STOP YOUR UNIT Push and hold the engine stop switch in the STOP or OFF position until the unit has fully stopped. Choke lever Trigger Primer Bulb Muffler ATTACHING THE SHIELD HOW TO START YOUR UNIT WARNING: The shield helps to protect the operator and others from thrown objects, and is equipped with a line limiter blade which WARNING: The trimmer head will turn 3 while starting the engine. A hot muffler can cause serious burns. COLD ENGINE STARTING OR STARTING AFTER REFUELING S Set unit on a flat surface. S Move choke lever to FULL CHOKE position. S Squeeze the throttle trigger fully and hold through all remaining steps. S Pull starter rope handle sharply 6 times. S Move choke lever to HALF CHOKE position. [. . . ] 30 DAYS - Parts and Labor, if used for rental purposes. This warranty is not transferable and does not cover damage or liability caused by improper handling, improper maintenance, or the use of accessories and/or attachments not specifically recommended by ELECTROLUX HOME PRODUCTS NORTH AMERICA for this tool. OWNER'S WARRANTY RESPONSIBILITIES: As the lawn and garden equipment engine owner, you are responsible for the performance of the required maintenance listed in your Owner's Manual. POULAN/ WEED EATER recommends that you retain all receipts covering maintenance on your lawn and garden equipment engine, but POULAN/WEED EATER cannot deny warranty solely for the lack of receipts or for your failure to ensure the performance of all scheduled maintenance. [. . . ]