User manual WELLTECH LAN PHONE 101 H.323

[. . . ] LAN Phone 101 User Manual Guide Document Ver. 1. 5 Notice © Copyright 2002 Welltech Computer Co. , Ltd. All intellectual property rights in this publication are owned by Welltech Computer Co. , Ltd. and are protected by Republic of China copyright laws, other applicable copyright laws and international treaty provisions. [. . . ] Note: Download via LCD command can only upgrade new application rom file. 2. 3. 4. Hardware Test LAN Phone 101 supports self-test for the all functions buttons. Please follow the direction from LCD panel to operate and verify it. Reboot (mandatory) It is necessary and important for user to reboot it after any configurations has been made to the LAN Phone 101. 17 Copyright (c) 2002 WellTech Computer Corporation LAN Phone Ver 109 Release 2002/06/07 LAN Phone 101 User Manual Guide Document Ver. 1. 5 Chapter 3 Advanced Configurations via Telnet After initializing the LAN Phone 101 IP Address setting (please refer to LCD Configuration: 1. Connect Configuration), user can enter into configuration mode via telnet. Note: 1. After user enter LAN Phone configuration via telnet, please use login:"root", password:"press enter" to enter command line. 2. Each command user must key-in with lower case, but contents of configurations such as h. 323 alias or user name etc, user can set as capital case. 3. User who changes any configuration needs to do the commit command then reboot command. 1. The following figure is shown all commands of LAN Phone 101. 18 Copyright (c) 2002 WellTech Computer Corporation LAN Phone Ver 109 Release 2002/06/07 LAN Phone 101 User Manual Guide Document Ver. [quit] command Type quit/exit/close will logout LAN Phone 101 and Program ­Telnet. 3. [reboot] command After doing commit command, type reboot to restart the LAN Phone 101. 4. [flash] command This command will clean the configuration stored in the flash rom to default value and reboot the LAN Phone 101. Note: After user upgrade new software version , suggested to execute this command to make sure new software work well on LAN Phone 101. Note: To execute the command flash ­clean, all configuration of LAN Phone 101 stored on flash rom will be cleaned. It is authorized for the user whose login name is "root" only. 5. [commit] command Save any changes after configuring the LAN Phone 101. 19 Copyright (c) 2002 WellTech Computer Corporation LAN Phone Ver 109 Release 2002/06/07 LAN Phone 101 User Manual Guide Document Ver. [ifaddr] command Configure and display the LAN Phone 101 IP information. -ip, -mask, -gate: Set LAN Phone 101 IP Address, subnet mask and default gateway respectively. -dhcp: When DHCP function enables (ifaddr ­dhcp 1), LAN Phone 101 will automatically search DHCP server after execute the commit and reboot command. Note: After LAN Phone catch a dynamic IP address form DHCP server, user can see this IP address on LCD connect configuration. -sntp: When sntp server is available, enable LAN Phone 101 SNTP function and point to sntp server IP address. (ifaddr ­sntp 1 "xxx. xxx. xxx. xxx") 4. [. . . ] rom ­boot :only "root" users can upgrade LAN Phone boot rom version. rom ­boot2m : only "root" users can upgrade LAN Phone 2mb firmware. Furthermore, there is permanent login and password for LAN Phone 101: login:"mac", password:"Mac address of Lan Phone(Please refer to label at the back of LAN Phone 101)" 32 Copyright (c) 2002 WellTech Computer Corporation LAN Phone Ver 109 Release 2002/06/07 LAN Phone 101 User Manual Guide Document Ver. 1. 5 Chapter 4 Upgrade the LAN Phone 101 LAN Phone 101 supports two methods to upgrade the new version released from Welltech Computer Co. [. . . ]