User manual WELLTECH WT 40458

Lastmanuals offers a socially driven service of sharing, storing and searching manuals related to use of hardware and software : user guide, owner's manual, quick start guide, technical datasheets... DON'T FORGET : ALWAYS READ THE USER GUIDE BEFORE BUYING !!!

If this document matches the user guide, instructions manual or user manual, feature sets, schematics you are looking for, download it now. Lastmanuals provides you a fast and easy access to the user manual WELLTECH WT 40458. We hope that this WELLTECH WT 40458 user guide will be useful to you.

Lastmanuals help download the user guide WELLTECH WT 40458.


Mode d'emploi WELLTECH WT 40458
Download
Manual abstract: user guide WELLTECH WT 40458

Detailed instructions for use are in the User's Guide.

[. . . ] One of four SIP Servers ( or ITSP Service provider or alternative IP-PBX ) can be configured freely at each line ( FXO port or FXS port ) to make or receive IP Call. It provides 4 service platforms according to your dial number or routes plan. [. . . ] More and more electronic devices are able to link to IP Network, this makes existing IPv4 address supply in short to global market. Meanwhile, the emerging countries are not able to increase IPv4 address supply due to strong market demand on broadband services. WellGate 2522 is an SIP based FXO plus FXS gateway which was built-in both IPv6 and IPv4 IP address. No matter when you are ready to deploy IPv6 network now, or reserve the future expansion to IPv6 from existing IPv4 address, WellGate 2522 is ready to grow up with you. Both IPv6 and IPv4 address are working simultaneously at Voice IP Call. Its flexibility of both IPv6 and IPv4 accept and interwork both addresses on today and tomorrow whenever you need. Upgrade existing PABX to enable VoIP call WellGate 2522 is a SIP IP device to connect with existing PABX and enable to make or receive VoIP call without affecting existing cabling, extension number or dial behaviors. It is an easy and quick way to upgrade existing PABX to VoIP calls. Do not expand your PABX's extension lines and analog trunk lines. Bypass PSTN line to PABX automatically if this device power is failure or IP network disconnection. It is an dependable solution to keep your PABX works as before. ITSP Service Provider WellGate 2522 (2FXS plus 2FXO) WellGate 2644 (4FXS plus 4FXO) IP-Network FXS Local PSTN FXO PBX trunk line Extension In office Office Existing Digital PBX SPECIFICATION Interface: Ethernet port (RJ-45, 10/100 base-T) 1-WAN port, connect to IP Network 1-LAN port connect to PC with NAT Support Bridge, NAT and Gateway mode Telephony port connect to local PSTN line (RJ-11 x 4 pcs) DC +12V power input Jack Reset key to return Factory setting LED Indicator for System, SIP, FXS and FXO status IP Network connection IPv4 (RFC 791) and IPv6 Simultaneously IPv6 Auto Configuration (RFC 4862) IPv6 Only, IPv4 Only or dual stack MAC Address (IEEE 802. 3) MAC Clone Setting Vendor Class ID IP/ICMP/ARP/RARP/SNTP Static IP DHCP Client (RFC 2131), WAN port DHCP Server, LAN port NAT Server (RFC 1631) PPPoE Client DDNS ( DynDNS ) DNS Client Firewall URL Filter IP Filter MAC Address Filter Application program Filter Port Filter Port Forwarding (TCP, UDP or both) Bandwidth Control (Download and Upload), Maximum Bandwidth priority setting UPnP Server at LAN port Behind NAT, use DMZ for NAT traversal SNTP with time zone and Daylight Saving TCP/UDP (RFC 793/768) RTP/RTCP (RFC 1889/1890) IPV4 ICMP (RFC 792), 2 Welltech Computer Co. , Ltd. 13F-4, No. 150, Jian Yi Rd. , Chung Ho City, Taipei, Taiwan Tel : +886. 2. 8226. 5699 Email : voipinfo@welltech. com, Fax : +886. 2. 8226. 5799 WEB: www. welltech. com WellGate 2522 2-Line FXO, 2-Line FXS SIP IP Gateway TFTP Client VoIP VLAN Support 802. 1Q, 802. 1P VLAN ID Range : 2 to 4094 VLAN Priority : 0 to 7 (Highest Priority) QoS : DiffServ (RFC 2475), TOS (RFC791, 1394) SIP Protocol : RFC3261 compliance Support up-to 4 SIP Trunk to Register SIP UDP Protocol Support SIP compact Form Support SIP HOLD Type: Send Only, 0. 0. 0. 0 or inactive SIP Session Timer (RFC 4028) SIP Session Refresher: UAC or UAS SIP Encryption MD5 Digest Authentication (RFC2069/RFC2617) Reliability of provision response PRACK (RFC3262) Early/Delay Media support Offer/Answer (RFC3264) Message Waiting Indication (RFC3842) Event Notification (RFC3265) REFER (RFC3515) Support Outbound Proxy Support Primary and Backup SIP Server Support STUN NAT Traversal Support "rport" parameter (RFC 3581) Configure SIP local Port SIP QoS Type: DiffServe or QoS Accept Proxy Only : YES or NO Audio Codec : G. 711 A-law/-law, G. 729A, G. 723. 1 (6. 3K, 5. 3K) Select voice codec priority : Local or Remote Voice Payload size (ms) configuration Silence Suppression VAD/CNG LEC : Line Echo Canceller Max Echo Tail Length (G. 168): 32, 64 and 128ms Packet Loss Compensation Automatic Gain Control In-band/out of band DTMF (RFC4733, RFC2833 / SIP INFO) Adaptive/Configurable Jitter Buffer G. 168 Acoustic Echo Cancellation Configure RTP basic Port RTP QoS Type : DiffServ or TOS Phone Book ( 50 records ) for peer to peer calls Dialing Plan with drop, replace, Insert dialing digits Select First digit and Inter digit timeout duration (Sec) Selectable Call Progress Tone Support Specified Line Calling Call Features : Support Peer to Peer Dialing 2-Line FXO connects to PSTN Line 2-Line FXS connects to analog phone set or PABX. Caller ID recognition DTMF (before/after 1st ring) and FSK (before 1st ring ), ETSI and Bellcore DTMF Caller ID start and stop BIT configurable Current Drop Detection to release FXO port Disconnect tone recognition to release FXO port Tone Generation: Ring Back, Dial, Busy, call waiting, ROH, Warning, Holding, Stutter dial tone and disconnect tone Configure Tone Frequency, Cadence, Level and Cycle Select Tone specification by Country name List Global Country Based Tone Specification NAT Traversal support STUN, UPNP and Behind NAT Out-Band DTMF : RFC2833 and SIP Info RFC2833 Payload type : 101 or 96 DTMF send out ON and OFF Time configure DTMF incoming recognition Minimum ON and OFF time DTMF Relay Volume configuration T. 38 FAX Volume configuration Flash Time transmit via SIP Info (Enable or Disable) Message Waiting Indication (Stutter Tone Notice) Block Anonymous Call Call Hold Call Transfer FXO/FXS Line Configuration: Activate or deactivate Line ID Line Phone number Polarity Reversal detection or generation for call establish and Billing. [. . . ] Current drop recognition or generation to release line Incoming call Handle: Hotline or 2 stage dialing HOT Line to desired phone number Play voice file to incoming call Repeat playing voice file counts Self-recorded voice files to upload Generate FLASH TIME to PSTN network T. 38 or FAX Relay Type Incoming and outgoing dB value configurable Dialing Answer Delay time to establish call path Answer PSTN incoming call after how many ring cycles Caller ID detection mode by Country selection VoIP dial to FXO/PSTN Line: 1 stage dialing and 2 stage dialing Outgoing SIP Caller ID Selection Support 4 SIP Trunk Accept desired SIP Proxy incoming calls Only Flexible Routing Plan : Prefix Match and Length Priority Ring Cyclic Ring Simultaneous Ring Programmable Hunting Cycle Backup Routes with Digit Manipulation Default Routes Flexible Dial Plans : Retrieve transfer call from 3rd party by dial Code (default: *#) Inter digit time out setting First digit dial out delay time setting End of dial keypad number Dial Rule : Match dial Prefix and Maximum digits length ( 1-15 ) 3 Welltech Computer Co. , Ltd. 13F-4, No. 150, Jian Yi Rd. , Chung Ho City, Taipei, Taiwan Tel : +886. 2. 8226. 5699 Email : voipinfo@welltech. com, Fax : +886. 2. 8226. 5799 WEB: www. welltech. com WellGate 2522 2-Line FXO, 2-Line FXS SIP IP Gateway Phone Book can be Exported or Imported Digit Manipulation (Drop and Replace Rule): FXO DM Group FXS DM Group VoIP DM Group DM 1 Group DM 2 Group DM 3 Group DM 4 Group Matched Prefix Matched digit length Replace digit start position Replace digit stop position Replace number FXS Analog 2-wire interface : Flash Time Detection: range from 80 to 800 ms ON-HOOK Voltage -48Vdc Configure Ring Cadence, Frequency and Voltage Support Polarity reversal for Billing Service Up to 1 Kilo-meter distance to analog telephone set Generate Current Drop Time (Open Loop Disconnect time) FXO Analog 2-wire interface : Incoming Ring frequency recognition range: 10 to 70 Hz Incoming Ring ON time recognition range: 0 to 8000ms Incoming Ring OFF time recognition range: 0 to 8000ms Incoming Ring Level recognition range: 10 to 95Vrms Flash Time Detection: range from 80 to 800 ms Configure Ring Cadence, Frequency and Voltage MANAGEMENT : Administrative Telnet CLI and HTTP, HTTPS HTTP provision through MAC address Multilingual Web User Interface 3 Levels of User Access Right with Password protection with different Web Language (Administrator, Supervisor and User) HTTP/HTTPS Service Access limitation from WAN port Configure Service ports at HTTP, HTTPS and telnet Services Phone Debug Module: Device Control, Call Control, DB, Verbose SIP Debug Module: Register, Call, SIP Message, Others SNTP Debug Module Device Debug Module DSP Debug Provide 8 Debug Levels : Emergency Alert Critical Error Warning Notice Information Debug Provides System Status Logs Connect to external SYSLOG Server Status display: Network, Line, SIP Trunk status Diagnostics (debug through Syslog Event Notice) Debug in real time by Telnet Auto Provision via HTTP Server SNMP V2/Trap Configuration Backup/Restore Dual Firmware Image Backup Reset to factory Default ** Support Welltech proprietary encryption protocol at SIP Signal and Voice codec during transmitting to IP network in order to Anti-ISP block of VoIP call. This feature only be available with Welltech SIP server or SIPPBX6200x IP-PBX Environmental : Actual Dimension: 17. 5(W) × 3. 2(H) × 12. 6(D) CM Weight: 0. 5kg (One unit with packing) Operating Temp. [. . . ]

DISCLAIMER TO DOWNLOAD THE USER GUIDE WELLTECH WT 40458

Lastmanuals offers a socially driven service of sharing, storing and searching manuals related to use of hardware and software : user guide, owner's manual, quick start guide, technical datasheets...
In any way can't Lastmanuals be held responsible if the document you are looking for is not available, incomplete, in a different language than yours, or if the model or language do not match the description. Lastmanuals, for instance, does not offer a translation service.

Click on "Download the user manual" at the end of this Contract if you accept its terms, the downloading of the manual WELLTECH WT 40458 will begin.

Search for a user manual

 

Copyright © 2015 - LastManuals - All Rights Reserved.
Designated trademarks and brands are the property of their respective owners.

flag