User manual WESTINGHOUSE MT25 ARM18 INSTALL GUIDE

[. . . ] This is shown with line "B" in the illustration below. Draw line "B" on your cabinet using a pencil. LINE "B" LINE "A" HALF WIDTH - 3/4" HALF WIDTH + 1 3/8" WALL PLATE WALL PLATE Note: Make both lines "A" & "B" at a 90° angle with the cabinet. 90° 90° OUTER EDGE OF CABINET BACK WALL OUTER EDGE OF CABINET BACK WALL Side of Cabinet 2 of 8 Visit the Westinghouse Web Site at www. westinghousedigital. com Side of Cabinet ISSUED: 04-22-04 SHEET #: 095-9195-1 For customer service call 1-866-287-5555. The depth of the cabinet and the size of your screen will determine which line "A" or "B" is closer to the outer edge of the cabinet. Use the line closer to outer edge of your cabinet as your centerline. This will ensure 180° of swivel around the side of your cabinet and that your screen will not hit the back wall in the closed position. [. . . ] Overtightening can damage the bolts, greatly reducing their holding power. · Never tighten in excess of 80 in · lb (9 N. M. ). fig 1. 3 I H Place wall plate over anchor (H) and secure with screw (I). WARNING · Concrete anchors are not intended for attachment to concrete wall covered with a layer of plaster, drywall, or other finishing material. If mounting to concrete wall covered with plaster/drywall is unavoidable, plaster/ drywall (up to 5/8" thick) must be counterbored as shown below. If plaster/drywall is thicker than 5/8", custom fasteners must be supplied by installer. After repeating figure 1. 1, tighten all fasteners. CUTAWAY VIEW I H WALL PLATE 4 of 8 Visit the Westinghouse Web Site at www. westinghousedigital. com ISSUED: 04-22-04 SHEET #: 095-9195-1 For customer service call 1-866-287-5555. For Wood Stud Walls, use a stud finder to locate center of stud. Make sure wall plate is level, drill two 3/16" (5 mm) dia. holes to a minimum depth of 2" (51 mm). Attach wall plate to center of wood stud using two #14 wood screws (I). WOOD STUD WALL WARNING · Tighten wood screws so that wall plate is firmly attached, but do not overtighten. Overtightening can damage the screws, greatly reducing their holding power. · Never tighten in excess of 80 in · lb (9 N. M. ). · Make sure that mounting screws are anchored into the center of the studs. The use of an "edge to edge" stud finder is highly recommended. WALL PLATE I Note: This product is designed to accommodate screens with VESA® compliant hole pattern. For safe mounting, please make sure that mounting screws turn at least three complete turns in the screen inserts. FOR VESA 75 MOUNTING PATTERN: 1) Choose hole pattern indicated below. 2) Attach adapter bracket (L) to back of screen using four 10 mm screws (M) as indicated below. 3) If hole pattern is in a pocket, attach adapter bracket (L) to back of screen using four 20 mm screws (N) and four retaining spacers (O) as indicated below. FOR VESA 100 MOUNTING PATTERN: 1) Choose hole pattern indicated below. 2) Attach adapter bracket (L) to back of screen using four M4 x 10 mm screws (M) as indicated below. Note: If you don't get three complete turns in the screen inserts, use four M4 x 12 mm screws (K) instead of four M4 x 10 mm screws (M). L For screens with a hole pattern in a pocket, spacers (O) go between adapter bracket (L) and screen. L Note: LCD screen may appear slightly different than illustrated. 5 of 8 Visit the Westinghouse Web Site at www. westinghousedigital. com ISSUED: 04-22-04 SHEET #: 095-9195-1 For customer service call 1-866-287-5555. Note: If the balljoint feels loose or too easy to adjust, slightly tighten cap socket screw until balljoint feels firmly in place. Insert two M5 x 10 mm screws (F) into top two holes of adapter bracket (L) leaving approximately 1/4" of exposed thread. [. . . ] PROOF OR ORIGINAL PURCHASE ­ A sales receipt, invoice, or other proof of purchase specifying the original date of purchase within the five (5) year warranty period must be presented to obtain warranty service. This warranty extends to the original purchaser and is not transferable. EITHER REPAIR OR REPLACEMENT IS YOUR EXCLUSIVE REMEDY UNDER THIS WARRANTY. EXCEPT TO THE EXTENT PROHIBITED BY LAW, WESTINGHOUSE DIGITAL SHALL NOT BE LIABLE FOR ANY INCIDENTAL OR CONSEQUENTIAL DAMAGES CLAIMED TO ARISE FROM BREACH OF ANY EXPRESS OR IMPLIED WARRANTY ON THIS PRODUCT. [. . . ]