User manual WESTINGHOUSE PHN798U

[. . . ] user manual Ceramic glass hob PHN768U, PHN798U 2 westinghouse Electrolux. Share more of our thinking at www. electrolux. com Contents Safety instructions . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2 Description of the Appliance . . . . . . . . . . . . . . . . . . . 3 Operating of the appliance . . . . . . . . . . . . . . . . . . . . . . [. . . ] · If all cooking zones are switched off, the cooking surface automatically switches itself off after approx. Control panel · When the appliance is switched off, if one or more of the sensor fields on the control Heat setting , - panel are covered for more that 10 seconds, an acoustic signal sounds. The acoustic signal switches itself off automatically when the sensor fields are no longer covered. Place a scraper on the glass ceramic surface at an angle. Remove residues by sliding the blade over the surface. Wipe the appliance with a damp cloth and a little washing up liquid. Rub the appliance dry using a clean cloth. Remove stubborn residues with a cleaner for glass ceramic or stainless steel. Scratches or dark stains on the glass ceramic that cannot be removed do not however affect the functioning of the appliance. Residues from cleaning agents will damage the appliance. Remove residues with water and washing up liquid. westinghouse 11 What to do if . . . Problem The cooking zones will not switch on or are not functioning. Possible cause More than 10 seconds have passed since the appliance was switched on The child safety device is switched on Several sensor fields were touched at the same time Automatic switch off has been triggered Remedy Switch the appliance on again. Deactivate the child safety device (See the section "Child safety device") Only touch one sensor field Remove any objects (pan, cloths, etc. ) that are lying on the control panel. Switch the appliance on again Switch off the lock (See the section "Locking/unlocking the control panel") Remove objects. The lock is switched on Acoustic signal sounds when appliance is switched off The control panel is wholly or partly covered by objects. The residual heat indicator The cooking zone was only on for a is not displaying anything short time and is therefore not hot The automatic warm up There is still residual heat on the function is not switching it- cooking zone self on The highest heat setting is set If the cooking zone is supposed to be hot, call the Customer Service Department. Let the cooking zone cool down The highest heat setting has the same power as the automatic warm up function 1. Set the cooking zone using the sensor field Do not place any objects on the control panel The heat setting was set using the sensor field Acoustic signal sounds and appliance switches itself on and then off again; after 5 seconds another acoustic signal sounds is lit The On/Off sensor field has been covered up, e. g. by a cloth Overheating protection for the cooking zone has been triggered Automatic switch off has been triggered Switch off the cooking zone. Switch the cooking zone on again Switch off the cooking zone. Switch the cooking zone on again Disconnect the appliance from the electrical supply for a few minutes (Take the fuse out of the house's wiring system) If after switching on again, is displayed again, call the customer service department and number are displayed Electronics fault If you are unable to remedy the problem by following the above suggestions, please contact your dealer or the Customer Care Department. Repairs to the appliance are only to be carried out by qualified service engineers. Considerable danger to the user may result from improper repairs. 12 westinghouse If the appliance has been wrongly operated, the visit from the customer service technician or dealer may not take place free of charge, even during the warranty period. Technical data Model PNC Product dimensions (w x d) mm Cut-out dimensions (w x d) mm Voltage (volts) Cycles (Hz) Service Cord Elements Left front Left rear Right front Right rear Total No. zones 3 1 1 1 PHN 768U 949 163 048 610 x 515 560 x 490 (485) 230 50 Not fitted Watts 2300/1600/800 1200 1200 1800 6500 No. zones 3 1 1 1 PHN 798U 949 163 049 930 x 520 880 x 490 (485) 230 50 Not fitted Watts 2300/1600/800 1200 1800 1200 6500 Disposal The symbol on the product or on its packaging indicates that this product may not be treated as household waste. Instead it should be taken to the appropriate collection point for the recycling of electrical and electronic equipment. [. . . ] During the Warranty Period Electrolux or its Authorised Service Centre will, at no extra charge if your appliance is readily accessible without special equipment, 16 westinghouse 5. 8. 9. and subject to these terms and conditions, repair or replace any parts which it considers to be defective. You agree that any replaced Appliances or parts become the property of Electrolux. This warranty does not apply to light globes, batteries, filters or similar perishable parts. [. . . ]