User manual WHARFEDALE ATMOS TWIN

[. . . ] - Use the appliance only for its intended purpose, i. - Use a mains supply which has an earth connection, for your own safety. - To avoid a circuit overload, do not operate another high wattage appliance on the same circuit. - Never plug in or pull the plug from the socket with wet hands. [. . . ] To release the connector reverse this procedure. ATTACHING CLOTH TO THE RECTANGULAR BRUSH Press down on end of clamp ; secure cloth under clamp ; release clamp. SETTING OF THE SPECIAL HARD FLOOR CLOTH ON THE RECTANGULAR BRUSH Use both hook-and-loop fasteners to set the cloth around the brush. Remove the anti-scale cartridge from the bag. place it firmly into the water reservoir. To obtain steam, the anti-scale cartridge must be inserted into the water tank. TyPES OF WATER You can use: tap water, distilled water for irons. Do not use: Rain water, water from the fridge, water from condenser tumble drier, water from any evaporator appliance, water supplied by your water softener if it indicates that the regenerating salts need replacing (incompatibility with the CAPT system). In order to ensure long life to your appliance, and prolong the lifetime of the anti-scale cartridge, we advise you to mix tap and demineralised water. Replace the reservoir by pushing it right into its housing. WICHTIG Never fill the reservoir with hot water. € Wait until the On/Off pilot light is permanently on, indicating that the appliance is ready for use again. An audible signal indicates that the appliance is ready to supply steam again. To obtain steam, press again the On/off steam switch (the pilot light on the handle will turn on). CAPT “ANTI-CALC”-System The electronic “CAPT” system measures the effectiveness of the antiscale cartridge by constantly monitoring the scale content of the filtered water. The “CAPT” system therefore eliminates any risk of scaling. CHANGE CARTRIDGE PILOT LIGHT A) When the anti-scale cartridge begins losing its effectiveness, the CAPT system is activated. The «ANTI-CALC» pilot light flashes in turn with the On/ off pilot light to show that the cartridge must be changed soon. B) If the anti-scale cartridge is not changed, the CAPT system itself stops the production of steam after a certain amount of cleaning time. To produce steam again, either the anti-scale cartridge must be changed or distilled water must be used. After changing the cartridge, the unit must be turned off and on again in order to recreate normal operating conditions. WICHTIG - 15 - It may take some time until steam comes out again when the cartridge has been replaced. [. . . ] - Set the position clip on one of the extension tubes and fix it on the top of one petal. € After cleaning, press the On/Off button to switch the appliance off. € All accessories can be put away between both petals. € The power cord and the flexible hose can be wound around the base of the appliance. [. . . ]