User manual WHIRLPOOL 30095134 MBI S40AL INSTRUCTION FOR USE

[. . . ] MBI 600 MBI 610 MBI 640 MBI S00 MBI S10 MBI S40 1 INSTALLATION PRIOR TO CONNECTING Check that the voltage on the rating plate corresponds to the voltage in your home. Do not remove the microwave inlet protection plates located on the side of the oven cavity wall. They prevent grease & food particles from entering the microwave inlet channels. Ensure the oven cavity is empty before mounting. [. . . ] Always use the Glass turntable as support when using the Crisp-plate. Do not place any utensils on the Crisp-plate since it will quickly become very hot and is likely to cause damage to the utensil. The Crisp-plate may be preheated before use (max. Always use the Crisp function when preheating the crisp-plate. WIRE RACK Use the Wire rack to put food on to allow the air to circulate properly around the food during cooking. Cooking large dishes with microwaves only gives best result if dish is placed on the wire rack (high position). START PROTECTION / CHILD LOCK This automatic safety function is activated one minute after the oven has returned to “stand by mode“. Putting food into it, before the safety lock is released. else the display will show “door“. PAUSE OR STOP COOKING To pause cooking: The cooking can be paused to check, turn or stir the food by opening the door. The setting will be maintained for 10 minutes. If you don’t want to continue cooking: Remove the food, close the door and press the STOP button A beep will signal once a minute for 10 minutes when the cooking is finished. Press the STOP button or open the door to cancel the signal. Note: The oven will only hold the settings for 60 seconds if the door is opened and then closed after the cooking is finished. To continue cooking: Close the door and press the Start button ONCE. The cooking is resumed from where it was paused. Pressing the Start button TWICE will increase the time by 30 seconds. CLOCK 1 Keep the door open while setting the Clock. This gives you 10 minutes to complete the setting of the Clock. Otherwise, each step must be accomplished within 60 seconds. Press the Stop button (3 seconds) until the left-hand digit (hour’s) flicker. Press the +/- buttons to set the minutes. [. . . ] When calling for Service, please give the serial number and type number of the oven (see Service label). Consult your warranty booklet for further advice. Important: If the mains cord needs replacing it should be replaced by the original mains cord, which is available via our service organization. The mains cord may only be replaced by a trained service technician. [. . . ]