User manual WHIRLPOOL 4211597

[. . . ] Using a pipe wrench, disconnect the drain line where It attaches to the disposer waste line pipe. Drawing shows just one model type. 6. If old disposer mounting is the same as your new one, insert end of jam-breaker wrench or screwdriver into right side of a disposer mounting ring lug at top of disposer. Hold disposer with other hand Turn jam-breaker wrench or screwdriver counterclockwrse until lug lines up with one of the sink-mounting assembly screws. Check that all parts were included. Drawing shows just one model type. Mounting assembly sink flange F!!v 2 rubber I ";y I screw I Caution: Potential gasket screw(s) metal flange Property Damage. Hold disposer with one hand while turning to prevent it from falling when the mountrng ring is disconnected. [. . . ] Insert strain relief Into hole Insert power supply cable through strain relief. Pull cable wires through opening where disposer wires are located. disposer wires using electrical wire nuts or by soldering wires together. Be sure to connect white to white, and black to black. Wrap wire connections with electrical tape. Note: This appliance is equipped with copper lead wires. If connection is made to aluminum house wiring, use only special connectors which are approved for joining copper to aluminum wires in accordance with the national electrical code and local codes and ordinances. 9 Make electrical connections l 1 _ C. Connect power supply cable wires to the B. Loosen screws on mounting assembly until they are level with mounting ring surface. C. Use screwdriver to pry off snap ring sleeve 1 D. Take assembly apart and set aside I w Electrical ground is required on this appliance. Failure to follow these instructions could result in death or electric shock. 7 A. If sink Apply rubber asket or putty so sink flange. Electrical ground is required on this appliance. DO NOT reconnect electrical current to main service panel until proper ground is installed. A. If the cable leading to the disposer has three wires, attach the green grounding wire to the green Qrounding screw. Go to Step 10-D The rubber sink flange gasket should always be used where possible. If the cable does NOT have a grounding wire, attach a length of copper wire (no smaller than the other cable wire) to the yreen yrounding screw metal cold water pipet IA. - U C. Attach the other end of the grounding wire opening does not permit the use of a rubber seal, plumber's putty may be used. Form putty into a long roll by rolling it between your hands. to a yrounded DO NOT ground to a gas supply line or hot water supply line. Use grounding clamp to secure wire to pipe. If non-metal or plastic pipe IS used In water connectrons or water supply you must have a qualifted electrician install a proper yround. *Grounded cold water pipe must have metal contlnulty to electrlcal ground and not be Interrupted by plastic, rubber or other electrIcallnsulatlny connectors such as hoses, flttlngs, washers, or gaskets (Including water meter or pump) C. Push down gently, but firmly to make sure flange sits evenly over yasket or In putty PANEL B D. Check to see if you have a water meter in your home. To have a grounded water pipe, the meter must have a wire clamp to either side of the meter. [. . . ] When attempting to remove objects from a waster disposer, use lony-handled tongs or pliers. Failure to follow these instructions result in serious injury. Before pressing red reset button, be sure the wall switch is In the off position and on batch feed models remove the stopper from the run position. b. GROUNDING INSTRUCTIONS FOR PERMANENTLY CONNECTED UNITS: This appliance must be connected to a grounded, metal, permanent wiring system; or an equipment-grounding conductor must be run wrth the clrcurt conductors and connected to the equipment-yroundiny terminal or lead on the appliance. Electrical Shock Hazard Electrical ground is required on this appliance. [. . . ]