User manual WHIRLPOOL 8300770

[. . . ] This symbol alerts you to potential hazards that can kill or hurt you and others. All safety messages will follow the safety alert symbol and either the word "DANGER" or "WARNING". These words mean: DANGER 31-3/8" overall height 30" cooktop width You can be killed or seriously injured if you don't immediately follow instructions. WARNING You can be killed or seriously injured if you don't follow instructions. All safety messages will tell you what the potential hazard is, tell you how to reduce the chance of injury, and tell you what can happen if the instructions are not followed. 30-3/4" recessed height from underside of cooktop to support slats shipping foot Important: Observe all governing codes and ordinances. 23-1/8" recessed depth 30" overall width Cabinet opening dimensions Countertop preparation: Front edges: You may need to shave or cut the trim of formed or metal front-edged countertops to clear the 30" width of cooktop. [. . . ] Connect directly to the fused disconnect (or circuit breaker box) through flexible, armored or non-metallic sheathed, copper cable (with grounding wire). Flexible armored cable from appliance should be connected directly to junction box. A U. L. -listed conduit connector must be provided at the junction box. Wire sizes and connections must conform with the rating of the appliance and to the requirements of the National Electrical Code, ANSI/NFPA 70 -- latest edition (**See Page 1) and all local codes and ordinances. If the house has aluminum wiring, follow the procedure below. a. ) Connect the aluminum wiring to the copper wire using special connectors designed and Underwriters Laboratories-listed for joining copper to aluminum. Follow the electrical connector manufacturer's recommended procedure. b. ) Aluminum/copper connection must conform with local codes and industry-accepted wiring practice. Installation steps D Check cooktop operation. D Check oven operation. C C Grasp oven frame to lift range. Use screws to attach range to cabinet. Remove side trim. C A Remove oven racks. A B Connect power supply cable. Remove trim screws. A C Remove shipping feet. C Replace oven door. A Remove oven door. A Preparation WARNING Excessive Weight Hazard Use two or more people to move and install range. Failure to do so can result in back or other injury. Important: Use both hands to remove oven door. Do Not use handle or any portion of the front frame or trim for lifting. Before moving range across floor, check that range is on shipping base or slide range onto cardboard or hardboard. Do Not remove shipping feet at the front lower corners of range. latch on the hinge in locked position ­ door free to open and close latch on the hinge in unlocked position ­ door ready for removal Remove trim screw. Pull trim out. Pull top of trim down. 1. Turn power supply off. · Remove and discard shipping materials, tape and protective film from the range. remove shipping base or shipping feet at the front lower corners of range. The shipping feet will protect the lower range trim until range is inserted into cabinet. · Remove and set aside oven racks and other parts from inside oven. etely open oven door. In both back corners of the door you will see door latches in the locked position. Rotate both latches forward to the unlocked position. [. . . ] See Use and Care Guide for troubleshooting list. NOTE: Refer to Use and Care Guide for operating instructions and cleaning instructions. If you need service: Maintain the quality built into your range by calling an authorized service company. To obtain the name and number of an authorized service company: Contact the dealer from whom you purchased your range; or Look in the Yellow Pages of your telephone directory under "Appliances -- Household -- Major -- Service and Repair" for an authorized service company; or Call the Consumer Assistance Center. The tollfree phone number is listed in your Use and Care Guide. [. . . ]