User manual WHIRLPOOL 906.2.02 PROGRAM CHART

[. . . ] Rating plate (at the side of crisper drawer) 9. Fan with filter (if present), see specific instructions for filter. B. [. . . ] It deactivates automatically after 26 hours). Fast Cool button, for appliances without a Freezer compartment (the function deactivates automatically after approx. The yellow LED stays on while the Fast Freeze function (or Fast Cool) is active. F. Button for muting the acoustic alarm (the alarm sounds if the door is left open for more than two minutes). The red LED flashes when the door open alarm is activated or when the letter “A” flashes on the display. “Child Lock”: to activate the function, press buttons F and D at the same time. children) from changing the temperature or selected functions. To deactivate the “Child Lock” function repeat the same procedure, long-pressing buttons F and D at the same time. D GB F NL E P I GR S N DK FIN REFRIGERATOR COMPARTMENT TEMPERATURE ADJUSTMENT The appliance is normally factory set for operation at the recommended temperature of +5°C. To adjust the internal temperature between +3°C and +7°C, proceed as follows: • Press button C once to adjust the internal temperature: the digital display will flash, showing the previously set temperature. • Each time the button is pressed, the temperature setting is changed by 1°C: the value (between +3°C and +7°C) flashes in sequence on the display. • Approximately 5 seconds after the button has been pressed for the last time, the set temperature is stored and the digital display stops flashing. • The temperature of the freezer compartment (approx. [. . . ] (10b) The fan will ONLY switch on when the compressor is running. Always remember to switch the fan off when the ambient temperature drops. D GB F NL E P I GR S N DK FIN 5019 608 01071 Printed in Italy 11/09 [. . . ]