User manual WHIRLPOOL ADG 4620 FD PRODUCT FICHE

[. . . ] The dishwasher door must be kept shut for the entire duration of the program in order to guarantee reduction of bacteria. If the door is opened the indicator lamp starts flashing. TABLET SETTING This setting allows to optimize the cycle performances according the type of detergent used. Push the Tablet button for 3 seconds (until the indicator lights up) if you are using the combined detergents in tablet (rinse aid, salt and deteregent in 1 dose). If you are using powder detergent or liquid detergent, the Tablet indicator on the control panel has to be off. DELAYED START BUTTON The wash cycle can be programmed to start after 2, 4 or 8 hours. [. . . ] To change the program in progress: - Open the door, press the CANCEL/Off button to cancel the running program and close the door. - (Water drains for up to 1 minute then the appliance switches off). - Open the door and press any button except CANCEL/Off button to switch on the appliance. - Press the START button and close the door within 3 seconds Switching off the appliance. Everything OK. . . 8 9 After the program is completed appliance turns into Standby mode automatically. Exercise caution when opening the door: beware of hot steam. Unload the appliance starting from the lower rack in order to avoid any residual drips of water falling onto crockery below. Maintenance and care Maintenance and care Screw on microfilter NOTE MARK!Unscrew microfilter (1), remove it (2) and remove fine sieve (3). . . Insert Filters Check and clean if necessary Rectifying minor faults yourself. . . 10 Insert and screw on upper and lower arms tightly. Clean spray nozzles under running water (use toothpicks if necessary). . . Spray arms Remove blockages/ deposits. GB -8- What to do if. . . If a fault occurs, before contacting the After-sales Service, make the following checks to try and remedy the problem. Most faults can be remedied by taking the following courses of action, quickly restoring normal appliance operation. - Close the salt reservoir cap properly. - If you use a combined action detergent, try adding more rinse aid. - Synthetic materials do not dry well; if wet at end of cycle, wipe dry. Clean dishes left in dishwasher for a long - In this situation, the presence of drops of water on dishes and on the sides of the time after end of cycle (e. g. Try releasing the door 5 minutes before removing the dishes. Incorrect arrangement of the concave - Arrange crockery so that water does not collect in cavities. - Increase the dosage of rinse aid (see page 4, “Adding rinse aid”). - The Rapid program 40°C / 45°C is intended for quickly washing lightly soiled dishes. If used for a full load of medium/heavy soiled dishes, the dishes may not dry completely. If so, select a standard-length program. For best results, open the door after the end of the program and wait 15 minutes before unloading the dishwasher. [. . . ] - Be careful when the door is open: risk of tripping!- The open dishwasher door can only support the weight of the loaded rack when pulled out. Do not rest objects on the open door or sit or stand on it. - Sharp items that might cause injury (e. g. [. . . ]