User manual WHIRLPOOL ADG 7680 WP INSTRUCTION FOR USE

[. . . ] Turn the selector knob to select the desired programme. The corresponding indicator lamp lights up. If required, select options (if supplied). Press the Start button to start the selected programme. [. . . ] The Start indicator lamp will switch off. Select a new programme and press the Start button. Note: If the dishwasher is switched off during a wash programme, when switched on again it will resume the wash cycle from where it was interrupted. Only open the dishwasher door if strictly necessary during a wash cycle and exercise maximum caution. To indicate the end of the programme, the Start indicator lamp switches off and the End indicator lamp (if fitted) switches on (for about 30 min. ). Turn the programme selector knob to the initial position to switch off the dishwasher (only after the Start indicator lamp has switched off). Open the door (warning: beware of hot steam). Unload the lower rack before the upper one. • • • • Upper and lower rack To lower: pull out the two side handles and gently lower the rack. To raise: pull up the two side handles until the rack clicks into place. Up: plates. Lower rack A A C Half load / Multizone: Loading the lower rack only gives greater washing power, especially for plates and saucepans. Crockery holders: • Upper rack “Flex 3”: multi-purpose support Plate holders: • (A) may be lowered to increase available space. B Half load / Multizone: If only the upper rack is to be loaded, place the cutlery basket (B) in the upper rack. To be used, for example, for longhandled utensils (arrange knives with the blade facing downwards), cups and glasses. • Are the spray arms blocked or the nozzles clogged?(See “Care and Maintenance” chapter in the user instructions). • Is the lower spray arm correctly fitted?• Is the salt container cap (water softening system) screwed down?Marked crockery: • Is the water hardness level selector not properly adjusted?See (“Filling the salt container” in the user instructions). (See “Filling the salt container” in the user instructions). (See “Filling the detergent dispenser” in the user instructions). Marked glasses and cutlery: • Was too much rinse aid used?(See “Filling the rinse aid dispenser” in the user instructions). Note: with some models, when the Start button is pressed a pre-wash cycle precedes the actual wash programme; this regenerates the water softening system. • AFTER-SALES SERVICE If after carrying out the above checks the malfunction persists or appears again, turn the appliance off and turn off the water supply tap, then call our After-Sales Service (see guarantee). [. . . ] Do not use the appliance for items not suitable for washing in a dishwasher, for example: wooden items, aluminium, plastic utensils, tin, hand-decorated crockery (unglazed), silver cutlery. Do not put liquid fat in the dishwasher (e. g. If a fault occurs or you wish to change the current programme, press the “START” button for about 5 seconds until the Start indicator lamp switches off. If regeneration salt is to be added, immediately start a wash programme in order to eliminate any residual salt (rinsing alone is not sufficient). [. . . ]