User manual WHIRLPOOL ADG 7720 WH PRODUCT FICHE

[. . . ] Press the Start button to start the selected wash programme. the Start indicator lamp will illuminate. Once set, the programmed data cannot be altered by turning the programme selector knob. Note: Once the Start button has been pressed, the dishwasher memorises the last programme selected. [. . . ] To change the selected programme, press the Start button for about 5 seconds, until the Start indicator lamp switches off. Select a new programme using the programme selector knob and press the Start button. Note: If the dishwasher is switched off during a wash programme, when switched on again it will resume the wash cycle from where it was interrupted. Only open the dishwasher door if strictly necessary during a wash cycle and exercise maximum caution. To indicate the end of the programme, the Start indicator lamp switches off and the End indicator lamp (if fitted) lights up (about 30 min. Turn the programme selector knob to the “0” position to switch off the dishwasher (only after the Start indicator lamp has switched off). Unload the lower rack before the upper one. Upper and lower rack Lower rack A A C Rack height adjustment: Upper rack (The dishwasher is delivered with the upper rack in the top position). The rack height can also be changed when loaded. €¢ To lower: pull out the two side handles and gently lower the rack. €¢ To raise: pull up the two side handles until the rack clicks into place. (See “Filling the salt container” in the user instructions). • Was insufficient detergent used?(See “Filling the detergent dispenser” in the user instructions). Marked glasses and cutlery: • Was too much rinse aid used?(See “Filling the rinse aid dispenser” in the user instructions). Note: With some models, when the Start button is pressed a pre-wash cycle precedes the actual wash programme; this regenerates the water softening system. AFTER-SALES SERVICE If, after carrying out the above checks the malfunction persists or appears again, turn the appliance off and turn off the water supply tap, then call our After-Sales Service (see guarantee). €¢ The service code (the number after the word Service on the adhesive rating plate) inside the door on the right-hand side. €¢ • • Important • Fill the detergent dispenser and check the salt and rinse aid level. €¢ Do not use the appliance for items not suitable for washing in a dishwasher, for example: wooden items, aluminium, plastic utensils, tin, hand-decorated crockery (unglazed), silver cutlery. €¢ Do not put liquid fat in the dishwasher (e. [. . . ] €¢ If a fault occurs or you wish to change the current programme, press the “START” button for about 5 seconds until the Start indicator lamp switches off. €¢ If regeneration salt is to be added, immediately start a wash programme in order to eliminate any residual salt (rinsing alone is not sufficient). €¢ Sometimes even though the regeneration salt container has been filled, the corresponding indicator lamp (if fitted) will light up during the first wash cycle after filling with salt. If a fault occurs, before contacting our After-Sales Service, make the following checks to try and remedy the problem: The dishwasher is not working: • Is the plug properly inserted in the wall socket? [. . . ]