User manual WHIRLPOOL ADG 8148 IX PROGRAM CHART

[. . . ] Antibacterial rinse 4) This function adds an antibacterial rinse at the end of the wash cycle, thereby guaranteeing a perfectly clean and sanitized load. The lamp will light up when the function is activated. If the temperature is not maintained during the antibacterial cycle (e. g. if the door is opened and remains open for a long time), the lamp will start blinking to indicate that sanitation is not guaranteed. Add rinse aid Programme chart Programmes Loading instructions Lightly, normally or heavily soiled, also Sensor max 1) 5) 40-70°C suitable for pans and saucepans. Detergent 2) A X X X Consumption 3) Litres kWh Minutes 90-162 14 55 30 B X - 7. 0-17. 0 0. 99-1. 58 4. 0 10. 0 10. 0 0. 03 0. 80 0. 65 Pre-Rinse Glass Quickwash 1) 2) 3) cold 40°C 40°C Crockery to be washed later. [. . . ] “Change programme in progress” Select additional options Press the Start button The selected programme is then memorised (even in the event of power failure). Press the START button for 2 sec. until the Start indicator lamp switches off. Select another programme and press the START button again. Wash cycle - Only open the dishwasher if necessary (Warning: beware of hot steam). - If the appliance is switched off during a wash cycle, when switched on again it will resume the cycle from where it was interrupted. Only after the START button has switched off: Press the ON / OFF button. Warning: When the door is opened steam comes out!Unload the appliance, starting from the lower rack. Switch off the appliance Turn off the water tap, unload the racks Dishwasher loading instructions and racks provided depending on the model Upper rack: Crockery holder (A): Depending on the position, for long-handles utensils, cups and plates. carving forks, knives) must be arranged with the sharp end facing in towards the appliance. B A C D Half Load: Load the upper rack (see description of Options). Place the cutlery basket (C), if provided, in the upper rack. Rack height adjustment (also when loaded): Pull the two rack handles (D) outwards and lower the rack. Pull the two rack handles (D) upwards until the rack Upper adjustment: clicks into place (factory setting). Lower adjustment: D Retainer open Retainer closed Removing the top rack to provide clearance for large items of crockery in the bottom rack: Open the rack guide retainers (E) on the right and left and remove the top rack. When the upper rack is in place the retainers must always be closed. E E Lower rack: Depending on the model with fixed or tilting plate holders (F). Half Load: Load the lower rack (see description of Options). Greater washing power, particularly for plates and saucepans. F F Cutlery basket (G): Grid (H) to keep items separate. Sharp knives and forks that might cause injury must be placed in the cutlery basket with the sharp end facing downwards. H G C Only use dishwasher-proof crockery and dishes. Do not use the appliance for items not suitable for washing in a dishwasher, for example wooden items, aluminium, tin, hand-decorated crockery (unglazed), silver cutlery. What to do if. . . If a fault occurs, before contacting our After-Sales Service, make the following checks to try and remedy the problem (* see also the corresponding chapter in the user instructions). Problem The appliance is not working Cause • No water supply. • The appliance does not load sufficient water. • Open the tap. Remedy • Clean the water supply tap filter. • Ensure there are no kinks in the water hose. • • • • Insert the plug into the mains socket. Check the safety circuit breaker. • Starting the selected programme. • The programme can be set to “0” to start. [. . . ] • Close the salt container lid properly *. • Change water hardness setting, if necessary add salt *. • Not removable • Insufficient water softening, calcium deposits. Opaque glasses/ glasses • Cannot be washed in the dishwasher. not sparkling Rust on cutlery Identifying appliance faults • Not made of stainless steel. • The START indicator lamp flashes. [. . . ]