User manual WHIRLPOOL ADG8674

[. . . ] Quick reference guide Chart BEFORE USING THE APPLIANCE FOR THE FIRST TIME CAREFULLY READ THIS QUICK REFERENCE GUIDE AND THE ASSEMBLY INSTRUCTIONS!THE CONTROL PANEL OF THIS DISHWASHER ACTIVATES PUSHING ANY BUTTON EXCEPT CANCEL/OFF BUTTON. FOR ENERGY SAVING THE CONTROL PANEL DEACTIVATES AUTOMATICALLY AFTER 30 SECONDS IF NO CYCLE HAS STARTED. OPERATION INDICATOR TABLET INDICATOR See TABLET setting in MULTIZONE description. WASH TIME DISPLAY A LED light projected on the floor indicates that the dishwasher is working. Indicates the cycle duration and the remaining time (h:min). With “Delayed start” selected it indicates the time remaining until program start (h. 00) - below 1h (0:min). [. . . ] - Check whether the “Delayed start” option (if available) has been selected. If it has, the appliance will only start once the set time has elapsed. If necessary, RESET the appliance by pressing CANCEL or start the cycle immediately by pressing START. - The water tap must be fully open during water inlet (minimum capacity: 0. 5 litres per minute). - The water inlet hose must not be kinked and the relative inlet filter in the water tap connector must not be dirty or clogged. bowls, cups) must be arranged facing downwards in the rack. - The drain hose must be fitted correctly (for high mounted appliances, leave min. 200-400 mm from the lower edge of the appliance) - see Assembly instructions. - Repeat without detergent or wait until foam disappears. - The closure disk of the syphon hose connection must be removed. - Call factory customer service (state fault display). Close the water tap. rinse aid indicator is lit . . . is not working/will not start . . . shows “F6 “H2O” E7” or “F6 E1” or - Water tap closed. - Kinked water inlet hose or clogged inlet filters. . . . shows “F6 E3”/wash program ended - Dirty or clogged filters or spray arms. too early (dishes are dirty and wet) - Too little water in the dishwasher’s water system. . . . shows “F8 E1” - Dirty filters. . . . shows other fault display “Fx Ey” - Appliance has technical defect. After taking the above course of action, the fault message must be reset. In the majority of cases the fault is thus eliminated. Water drains automatically for up to 1 minute. The appliance is now ready to be restarted. EN -9- What to do if. . . Crockery and cutlery. . . . . . are not perfectly clean/have food residues Possible causes. . . - T little space between dishes (incorrect oo arrangement of the concave items in the rack). - Too little detergent; detergent too old or incorrectly stored. - Temperature not high enough for heavily soiled crockery. - Loading of the dishwasher using lower and upper rack at the same time with “Half load/ Multizone” option. [. . . ] knives), must be placed in the cutlery basket with the sharp end facing downwards. Long-handled utensils must be arranged horizontally in the upper rack, with the sharp end facing away from the front of the appliance. We reserve the right to make technical modifications. - Before cleaning or carrying out maintenance, disconnect the mains plug and turn off the water tap; also in the event of any malfunction. [. . . ]