User manual WHIRLPOOL ADP 560 A WH PRODUCT FICHE

[. . . ] Water and electrical connections • All water and electrical connections must be carried out by a qualified technician in compliance with the manufacturer’s instructions (refer to the enclosed assembly instructions) and current local safety regulations. The appliance must only be used in the household for the prescribed uses. • PROTECTING THE ENVIRONMENT 1. Packaging The packing box may be fully recycled as confirmed by the recycling symbol . Energy and water saving tips • Do not rinse crockery under running water. [. . . ] • Fix the drain hose to the siphon with a clamp to prevent it from coming off during operation. • For appliances with water-stop system only: If the water connections are made correctly according to the instructions, the water-stop system safeguards your home against damage caused by flooding. Electrical connection: • Observe the current regulations issued by your local electricity supplier. • Voltage information is shown on the rating plate mounted inside the door on the right hand side. • The appliance must be earthed as prescribed by law. • Do not use extension leads or multiple adapters. • Before carrying out maintenance, disconnect the mains plug. • The power cable must only be replaced by a qualified technician. • The manufacturer cannot be held responsible for damage caused by incorrect earthing of the appliance. • For Austria: if the appliance is series connected to a fault current switch, this must be sensitive to the pulsating current. 12 ELECTRICAL CONNECTION For Great Britain Only The wires in the mains lead are coloured in accordance with the following code: BLUE - “NEUTRAL” (“N”) BROWN- “LIVE” (“L”) GREEN AND YELLOW - “EARTH” (“E”) 1. • If all of the test squares become red, set the hardness selector to 3. How to fill the salt container: Warning: only use dishwasher salt!Do not fill the salt container with unsuitable substances, such as detergent, as this will cause irreparable damage to the water softener system. Unscrew the cap by turning it counter-clockwise. When first using the dishwasher: fill the salt container with approximately 1 litre of water. Fill the salt container to the rim with salt (using the funnel provided) (when filling for the first time use min. 2 kg) and stir with a spoon handle. 5. Screw the cap back on by turning it clockwise. After filling the regeneration salt container, immediately start a wash programme (the Prewash programme alone is not sufficient), so as to eliminate any residual saline solution straight away and avoid corrosion. Check the salt level regularly. Salt level indicator: The dishwasher is equipped with an electric or visual salt level indicator (depending on the model installed). Electric indicator: The salt level indicator lamp on the control panel lights up when the salt container is empty. [. . . ] Unscrew the rinse aid dispenser cap by turning it counter-clockwise and lift it up (see drawing). If crockery is prone to lime streaks, reduce the dosage by turning the dial to a lower setting using a coin or the back of a spoon. If crockery is not perfectly dry, increase the dosage by turning the dial to a higher setting (4-6). Replace the cap and close it by turning fully clockwise.  9LVXDOLQGLFDWRU Rinse aid level indicator: Visual indicator: Dark Light = = sufficient rinse aid. [. . . ]