User manual WHIRLPOOL ADPL7020IX

[. . . ] Quick reference guide Chart BEFORE USING THE APPLIANCE FOR THE FIRST TIME CAREFULLY READ THIS QUICK REFERENCE GUIDE AND THE ASSEMBLY INSTRUCTIONS!FOR ENERGY SAVING THE CONTROL PANEL DEACTIVATES AUTOMATICALLY AFTER 30 SECONDS IF NO CYCLE HAS STARTED. ECO PROGRAM INDICATOR Indicates the cycle duration and the remaining time (h:min). With “Delayed start” selected it indicates the time remaining until program start: “h24” if above 10 hours delay time remain and “h:mm” if below 10 hours delay time remain. If “Fx Ey” messages appears on the display, see page 8 - chapter “What to do if. . . ”. WASH TIME DISPLAY When lit, it indicates that standard program is active. When lit, it indicates that delay is active. DELAY INDICATOR When lit (at the end of the cycle), the salt reservoir needs to be refilled. SALT INDICATOR When lit (at the end of the cycle), the rinse aid dispenser needs to be refilled. RINSE AID INDICATOR When lit, it indicates the wash in the upper or lower rack only. MULTIZONE INDICATOR WATER TAP CLOSED - Alarm Blinks when there is no inlet water or water tap is closed. When lit, it indicates that keyboard lock is active. KEYBOARD LOCK INDICATOR PROGRAM SELECTION BUTTON MULTIZONE Push “P” button (repeatedly) until selected program number is shown on the display (P1. . . Px) see “Table of programs” - next page. [. . . ] - The water inlet hose must not be bent and the relative inlet filter in the water tap connector must not be dirty or clogged. bowls, cups) must be arranged facing downwards in the rack. - The drain hose must be fitted correctly (for high mounted appliances, leave min. 200-400 mm from the lower edge of the appliance) - see Assembly instructions. - Repeat without detergent or wait until foam disappears. - The closure disk of the syphon hose connection must be removed. - Call factory customer service (state fault display). Close the water tap. rinse aid indicator is lit . . . is not working/will not start . . . shows “F6 E7” or “H2O” + Water Tap indicator - Water tap closed. - Bent water inlet hose or clogged inlet filters. . . . shows “F6 E3”/wash program ended too - Dirty or clogged filters or spray arms. early (dishes are dirty and wet) - Too little water in the dishwasher’s water system. . . . shows “F8 E1” - Dirty filters. . . . shows other fault display “Fx Ey” - Appliance has technical defect. After taking the above course of action, the fault message must be reset. In the majority of cases the fault is thus eliminated. Water drains automatically for up to 1 minute. The appliance is now ready to be restarted. EN -8- What to do if. . . Crockery and cutlery. . . . . . are not perfectly clean/have food residues Possible causes. . . - T little space between dishes (incorrect oo arrangement of the concave items in the rack). - Too little detergent; detergent too old or incorrectly stored. - Temperature not high enough for heavily soiled crockery. - Loading of the dishwasher using lower and upper rack at the same time with “Half load/ Multizone” option. - Clogged spray arms, dirty filters or not fitted correctly. - Spray arms stuck impeded by crockery or cutlery. Solutions. . . - Arrange crockery so that items do not touch each other. bowls, cups) must be arranged facing downwards in the rack. - If necessary, use more detergent, observing the manufacturer’s indications as regards dosage. [. . . ] knives), must be placed in the cutlery basket with the sharp end facing downwards. Long-handled utensils must be arranged horizontally in the upper rack, with the sharp end facing away from the front of the appliance. The guarantee is not applicable if faults are caused by incorrect use of the appliance. We reserve the right to make technical modifications. [. . . ]