User manual WHIRLPOOL AGB 413/WP INSTRUCTION FOR USE

Lastmanuals offers a socially driven service of sharing, storing and searching manuals related to use of hardware and software : user guide, owner's manual, quick start guide, technical datasheets... DON'T FORGET : ALWAYS READ THE USER GUIDE BEFORE BUYING !!!

If this document matches the user guide, instructions manual or user manual, feature sets, schematics you are looking for, download it now. Lastmanuals provides you a fast and easy access to the user manual WHIRLPOOL AGB 413/WP. We hope that this WHIRLPOOL AGB 413/WP user guide will be useful to you.

Lastmanuals help download the user guide WHIRLPOOL AGB 413/WP.


Mode d'emploi WHIRLPOOL AGB 413/WP
Download
Manual abstract: user guide WHIRLPOOL AGB 413/WPINSTRUCTION FOR USE

Detailed instructions for use are in the User's Guide.

[. . . ] We recommend installing the machine under a range hood so that all the fumes are removed as quickly as possible. If the appliance is to be installed near walls, dividing walls, kitchen equipment or decorative pannelling, these should be in non-inflammable material or covered with non-inflammable material. Make sure that all fire prevention standards and safety precautions are strictly adhered to. Installation Installation, start-up and maintenance should only be carried out by expert personnel. All work required to install the appliance should be carried out in compliance with all local standards and regulations. [. . . ] All work required to install the appliance should be carried out in compliance with all local standards and regulations. The manufacturers decline all responsibility where poor performance is due to incorrect installation in disregard of the above conditions. Warning! In compliance with international regulations, when connecting the appliance to the mains power supply, a device with a minimum aperture of 3 mm between contacts must be fitted upstream of the appliance, allowing omnipolar disconnection of the appliance from the mains. Wiring When choosing the lead wire, make sure it has the following characteristics: it should be at least of the H07 RN-F type and its section should be large enough for the appliance (see "Technical specifications and dimensions", page 4). Wire entry on top models is on the back wall, and underWarning!In both cases the terminal board is MODEL AGB 449/WP if this model is going to be mounted on its own, it must at the front, behind the control panel. Pass the wire through the core hitch and wire clamp, plug The appliance should be fitted following the indica- the leads into their terminals on the board and secure them. The earth lead must be a little longerthan the others so 1 RETRO that it is the last lead to disconnect if the wire clamp BACK ARRIERE breaks. RÜCKSEITE Unipotential The appliance must be connected up to a unipotential system. The connection screw is located on all top models at the back on the right hand side, while in other models it is located underneath the appliance on the right hand side. It is labelled. Connection to waterworks Legal and technical requisites - Water inlet pressure must be between 50 and 300 kPa, When installing the appliance, the following safety stan- otherwise install a pressure regulator on the line before the appliance. dards must be adhered to: - Install a cut-off valve for each supply on the line before the appliance. - Never leave the appliance on without water! Warning! Emptying the bath Open the outlet tap located in the machine’s lower space. Precautions during use Sauces and condiments: TAKING CARE OF THE APPLIANCE all the stainless steel containers used for notoriously acid ingredients (vinegar, salt, lemon juice, tomatoes, etc. ) FREQUENCY OF MAINTENANCE Giving the appliance a thorough clean every day (after should be thoroughly washed to remove any residue. turning it off) will keep it in perfect working order and make In particular salt solutions should not be left to evaporate or dry on the stainless steel surface. Never use coarse cooking salt which, being heavy, deposits on the bottom without dissolving completely and Warning!Never clean the appliance with jets of water, whether over a period of time can therefore cause points of contact with consequent corrosion. It is therefore advisable to add salt in small amounts to waAllow the machine to cool down before cleaning Before starting to clean the appliance, disconnect from ter which is already boiling, or to dissolve it in a separate container; never add it to cold water in the tanks and certhe mains. After having emptied the tank, remove the false botttom. Whenever the tanks are not being used, they should preferably remain uncovered. Daily cleaning Frequently clean the surfaces using a damp cloth; water and soap or common detergents may be used provided they do not contain abrasives or chlorine-based substances, such as sodium hypochlorite (bleach), hydrochloric acid (muriatic acid), or other solutions: stainless steel is quickly and irreversibly corroded by these products. Under no circumstances use the above-mentioned 027- 03 - Electric pasta cooker 6 Protection of stainless steel Should the equipment not be used for a certain period of time, clean the external stainless steel surfaces and when they are completely dry, protect by spreading over them a thin film of vaseline oil, or better still specific products. The 2002/96/EC (WEEE) Directive: information to users This informational note is meant only for owners of equipment marked with the symbol shown in Fig. A on the adhesive label featuring the technical specifications applied on the actual product (the label also giving the serial number). What to do if not using the appliance for a long time Thoroughly clean and dry the machine as described. [. . . ] Under no circumstances use the above-mentioned 027- 03 - Electric pasta cooker 6 Protection of stainless steel Should the equipment not be used for a certain period of time, clean the external stainless steel surfaces and when they are completely dry, protect by spreading over them a thin film of vaseline oil, or better still specific products. The 2002/96/EC (WEEE) Directive: information to users This informational note is meant only for owners of equipment marked with the symbol shown in Fig. A on the adhesive label featuring the technical specifications applied on the actual product (the label also giving the serial number). What to do if not using the appliance for a long time Thoroughly clean and dry the machine as described. This symbol indicates that the product is classified, accorDisconnect the power supply. ding to the regulations in force, as an item of electrical and electronic equipment and conforms to EU Directive What to do if something goes wrong 2002/96/EC (WEEE) meaning that, at the end of its service If anything goes wrong, immediately turn the appliance life, it must be treated separately from domestic waste, i. e. [. . . ]

DISCLAIMER TO DOWNLOAD THE USER GUIDE WHIRLPOOL AGB 413/WP

Lastmanuals offers a socially driven service of sharing, storing and searching manuals related to use of hardware and software : user guide, owner's manual, quick start guide, technical datasheets...
In any way can't Lastmanuals be held responsible if the document you are looking for is not available, incomplete, in a different language than yours, or if the model or language do not match the description. Lastmanuals, for instance, does not offer a translation service.

Click on "Download the user manual" at the end of this Contract if you accept its terms, the downloading of the manual WHIRLPOOL AGB 413/WP will begin.

Search for a user manual

 

Copyright © 2015 - LastManuals - All Rights Reserved.
Designated trademarks and brands are the property of their respective owners.

flag