User manual WHIRLPOOL AGB 777/WP INSTRUCTION FOR USE

[. . . ] To light up the cabinet’s it is advisable to use fluorescent lamps. The cabinet must be leaned against the wall but before leaning it verify if inside the instruction kit there are some spacers to put on its back. In case it must be shifted, first take the socket off the current-tap. Whenever, if due to any installation reasons, you cannot lean the unit to the wall , you have to assemble the motor room protection grill to the lead screws placed on the back lower sides of the unit (you can ask for the needed material to the producer). [. . . ] To make it useless cut off the feeding cable and take the door off. 5 PERIODICAL MAINTENANCE For any adjustments on the refrigeration you must remove the electric plug. The mechanic parts of the cabinet do not need any periodical maintenance, still for a good preservation of the cabinet an accurate periodical cleaning is necessary: EXTERNAL BODY: when necessary, the external body should be cleaned with a soft dry cloth. To remove stains use warm water and neutral soap then rinse well and dry . €¢ STAINLESS STILL SURFACES: wash with warm water and neutral soap, rinse well and dry with a soft cloth. Avoid the use of alcohol, methylated spirits or other solvents. • SURFACES IN PLASTIC MATERIALS: wash with water and neutral soap. Avoid the use of alcohol, methylated spirits or other solvents. €¢ GLASS SURFACES: only use product specific for glass cleaning. Avoid to use water that could leave a film of calcium on the glass surfaces. for the tank cleaning proceed as follows: 1. Switch off the unit and remove the plug from the socket 2. Remove the products and the shelves from the cabinet 3. Leave the door open and wait that the cabinet temperature is equal to the ambient one 4. Wash the inside of the cabinet with water and neutral soap then dry it with a cloth 5. Do not use jet of water to clean the cabinet: electrical wiring can be damaged • then replace the shelves and switch on the cabinet with the light off: after 1 hour the unit is ready and you can put the products in. Once a year clean the door sealing using warm water and neutral soap. Rinse well and dry; afterwards you should apply a light layer of vaseline to keep the sealing soft and flexible. Do not use pointed or cutting objects that could damage the sealing. CONDENSER CLEANING Warning: the following procedure is to be performed only by an specialised technician. At least four times a year, proceed to the cleaning of the condenser in order to remove dust and impurity, which may obstruct the air flowing. A dirty condenser could damage the performance of the cabinet, increasing the electric energy consumption. [. . . ] 7 SEASONAL USE AND/OR NON-USE When the cabinet will not be used for a long time, please proceed as follows: 1. Before the standing period: • Take the plug off the socket; • Defrost clean and dry the inside and outside of the cabinet; • Leave the glass door open to avoid possible formation of bad smells; • Cover the cabinet with a curtain, place it in a dry room and repaired from atmospheric agents; When the cabinet will be started up again: • • Repeat the electric checking given in PUTTING INTO OPERATION; Wait for two hours at least before putting the products inside. 8 SETTING AND CONTROLS On the front top of the cabinet there is the control panel with switchers and control lights (1) Lights switcher: Switching it on you light the inside lamp (for the model with the canopy it also light it). (2) Thermometer The inside temperature is indicated on the horizontal reading thermometer (3) Thermostat To regulate temperature use the hand thermostat that is on the control panel. [. . . ]