User manual WHIRLPOOL AGB 783/WP INSTRUCTION FOR USE

[. . . ] Attention: both the power system and the premises where such appliances are installed must comply with the current regulations. The manufacturer will not be liable for any direct or indirect damage arising from noncompliance with the said regulations. 3 SETTING UP THE APPLIANCE After removing all packaging material place the dishwasher where it is to be installed and level by means of the adjustable feet. Slowly peel off all protective film and stickers. [. . . ] The exact quantity of polishing liquid required for each rinse cycle is automatically released. Adjustments should be carried out by detergent suppliers. 7 SAFETY DEVICE 1) Door microswitch to stop the cycle when the door is opened; close the door to restart. 4) Device preventing boiler water from flowing back into the mains. 5) Overflow device connected to the drain to keep tank water level constant. 6) Safety thermostat on the boiler to stop the power in case of overheating so as to prevent possible damage. Should the safety thermostat come into action: - remove the appliance bottom panel; - let the boiler cool down; - make sure the boiler thermostat is working correctly; replace if necessary; - check the boiler heating electromagnetic switch and replace if necessary (only for threephase 400V mod. ); - start the appliance again by pressing button R on the safety thermostat (Fig. 8 SAFETY INSTRUCTIONS AND USER TRAINING The skilled staff in charge with installation and wiring operations will also suitably train users to use the appliance correctly. Users should be made familiar with any safety instructions to be complied with. The instruction handbook should be kept by users for further reference. This appliance is only designed for professional use. The manufacturer wil not be liable for any damage arising from tampering the safety devices. ENGLISH 23 ISTRUCTION FOR USERS The appliance is only designed for the professional washing of small plates, glasses and cutlery. The manufacturer will not be liable for any direct or indirect damage arising from incorrect use of the appliance or use of products other than the said ones. 9 CHECKINGS BEFORE USE Before powering the machine make sure: - tank protection filters are clean and correctly positioned; - the overflow device is located in the relevant position; - wash and rinse blades are clean and freely moving; - the wall master switch is on; - the water tap is on; - the washing and rinsing arms are free of impurities and are at the right angle. 10 FILLING THE TANK AND START-UP When the door is closed, move the main switch 1 to the 1 position: the power pilot light 2 will come on and at the same time the boiler and the tank will start to fill. 11 STARTING Wait until the machine has reached the right temperature (light 11 off), carry out one empty cycle then place the basket in the dishwasher having removed leftovers and scraps from the dishes. Pour non-foaming washing liquid in the correct quantity as recommended by the Manufacturer. Close the door, press button 3 to start the wash cycle, at the same time pilot light 4 will come on. When the rinsing cycle has finished (light 4 off), open the door, remove the basket and leave it for a few minutes in the air to help dry the dishes. If the door is opened during a programme, the programme will stop and will only start again when the door has been closed. [. . . ] To clean the floor under the appliance or around it, do not use the products referred to above to prevent vapours or any droplets from producing similiarly destructive effects on the steel. Rub the surfaces only in the direction of the silking. Then rinse thoroughly with clean water and dry carefully. 2 DAILY, ROUTINE CLEANING OPERATIONS APPLIANCES WITH DISCHARGE PUMP Unscrew the ring nut and remove the filter taking care to clean it thoroughly (Fig. [. . . ]