User manual WHIRLPOOL AKR 191/IX INSTRUCTION FOR USE

[. . . ] • The control box can be installed on a cabinet panel with a thickness (D) included between 16 and 24 mm. • • Before installation check the cabinet panel thickness and adjust spacers (E) as shown in the opposite figure. Embed the control box until the two springs (F) and the two spacers (E) hook into the cut-out. 86 INSTALLATION Cooktop • The cooktop must be set into a worktop between 20 mm and 50 mm thick. There must be nothing between the cooktop and the control box (cross rails, brackets, etc. ). If the cooktop is to be installed next to a column unit, leave a distance of at least 100 mm from the edge of the cooktop to the side of the column unit. [. . . ] N. B: The cooling fan runs continuously at two different speeds according to the temperature value of the components when the appliances are in use. • Full speed: for high temperature of the components. Half speed pulsing: for low temperature of the components. The pulsing speed has to be considered a normal appliance condition at half speed. The fan may continue to run for the time necessary to ensure sufficient cooling of the components and adjacent kitchen units after the appliance has been switched off. ENERGY SAVING TIPS • Use pots and pans whose bottom diameter is equal to that of the cooking zone or slightly larger. If possible, keep the pot covered when cooking. with little water in order to cut down cooking time. A pressure cooker allows you to save even more energy and time. • • • • NO! OK!Packing • The packaging material can be 100% recycled, as confirmed by the recycling symbol ( ). Products • The appliances are built from recyclable materials. If you decide to scrap the appliances act responsibly and observe local waste disposal by laws. Cut off the power cords so that the appliances cannot be connected to the mains. . 89 PRECAUTIONS AND GENERAL RECOMMENDATIONS • Before any maintenance on the appliances disconnect them from the electrical power supply. Keep children away from the appliances when they are in use. The appliances must be repaired or adjusted exclusively by a qualified technician. Make sure that the electrical wires of other electrical appliances near the cooktop do not come into contact with hot parts. Specific recommendations for glass-ceramic cooktops • If the glass ceramic surface should break or crack due to violent impact (falling objects, etc. ) do not use it and call After Sales Service immediately. Do not place food wrapped in aluminium foil, plastic containers or cloths on the hot cooking zones. Do not drag pans across the glass-ceramic surface - risk of scratches. Avoid spilling sugar and similar substances on the cooktop. If necessary, clean the cooktop carefully following the care and maintenance instructions in this handbook. These appliances are designed to come into contact with foodstuffs and they are constructed in compliance with Directive 89/109/EEC. [. . . ] • Control knob set to “0”?Set the main disconnect switch upline of the appliance to “OFF” for a few minutes and then back to “ON” and see if the problem persists. AFTER SALES SERVICE Before contacting After Sales Service: 1. Try to solve the problem (see “Troubleshooting guide”). Turn off the appliance and restart it to see if the fault is repeated. [. . . ]