User manual WHIRLPOOL AKR 808 BK MANUAL DE INSTRUÇÕES

[. . . ] La distance minimum entre le support de panneau de la table de cuisson et la base de la hotte doit être d'un minimum de 40 cm pour les tables de cuisson électrique et de 65 cm pour les tables de cuisson au gaz au mixte. € Acesta este simbolul de atenţionare referitor la siguranţă, care alertează utilizatorii cu privire la potenţialele pericole la care sunt expuşi ei înşişi şi cei din jur. € Denna apparat får inte användas av barn (8 år och över) eller av personer med nedsatt fysisk, sensorisk eller mental förmåga, eller med bristande erfarenhet och kunskap, såvida de inte noggrant övervakas eller har fått instruktioner om hur den ska användas på ett säkert sätt och känner till alla faror som är kopplade till dess användning. € Använd luft får inte ledas ut till en kanal som används till rökutsug från en apparat som förbränner gas eller annat bränsle. [. . . ] check whether the appliance has been damaged in transit. During use Do not place heavy items on the appliance as this may cause damage. Do not expose the appliance to atmospheric agents. eN84 SAFEGUARDING THE ENVIRONMENT Disposing of packaging material The packaging material is 100% recyclable and is marked with the recycling symbol ( ). Do not dispose of the various packaging carelessly, but do so responsibly and in full compliance with local authority regulations governing waste disposal. Scrapping the product -- This appliance is marked in compliance with European Directive 2012/19/EU on Waste Electrical and Electronic Equipment (WEEE). -- By ensuring that this product is disposed of correctly, you will help prevent potentially negative consequences for the environment and human health. -- The  symbol on the product or on the accompanying documentation indicates that it should not be treated as domestic waste but must be taken to an appropriate collection centre for the recycling of electrical and electronic equipment. scrapping household appliances • This appliance is manufactured using recyclable or reusable materials. Scrap the appliance in accordance with local regulations on waste disposal. Before scrapping, cut off the power cable so that the appliance cannot be connected to the mains. € For further information on the treatment, recovery and recycling of household appliances, contact the competent local authority, the domestic waste collection service or the shop where you purchased the product. TROUBLESHOOTING GUIDE The appliance does not work: • Check the mains voltage and whether the appliance is connected to the power supply; • switch the appliance off and on again to see if the fault persists. The hood is not extracting air sufficiently: • Check that the air extraction speed is set to the desired level; • Check that the filters are clean; • Check the air vents for any obstructions. The lamp does not work: • Check the bulb and replace if necessary; • Check that the bulb has been fitted correctly. aFTER-SALES SERVICE Before calling the After-sales Service: 1. Check whether you can solve the problem yourself by following the suggestions given in the “Troubleshooting guide”. Switch the appliance off and on again to see if the fault persists. If the fault persists after carrying out the above checks, contact the nearest After-sales Service. Always provide: • A brief description of the fault; • The type and exact model of the appliance; • The Service number (the number after the word "SERVICE" on the identification plate), located on the inside of the appliance. The Service number is also stated in the warranty booklet; • Your full address; • Your telephone number; If any repairs are required, please contact an authorised After-sales Service Centre (to ensure that original spare parts are used and repairs are carried out correctly). eN85 CLEANING WARNING   -Do not use steam-cleaning equipment. [. . . ] Turn the filters to secure them to the central pins. Re-fit the grease filters and close the panel. If you want to install the chimney section: Rest the chimney on top of the hood, remove the top section and fix the chimney using two screws, as shown. Check that the hood is working properly, referring to the section on the description and use of the hood. [. . . ]