User manual WHIRLPOOL AKR 968 INSTALLATION

[. . . ] D INSTALLATIONSANLEITUNGEN Der Mindestabstand zwischen dem Kochfeld und der unteren Kante der Dunstabzugshaube muss bei Elektroplatten 50 cm und bei Gasherden oder kombinierten Herden 65 cm betragen. Schreiben die Installationsanweisungen des Gaskochfelds einen greren Abstand vor, ist dieser natrlich zu beachten. Sie sollten einen qualifizierten Techniker mit der Installation beauftragen. Folgen Sie bei der Installation der Nummerierung (1 2 3 . . . . . ). [. . . ] Adjust the distance between the hood and the wall. Fix the hood securely to the wall (ABSOLUTELY NECESSARY!!). Connect an exhaust pipe (pipe and clamps are not supplied and must be bought separately) to the collar located above the extraction motor unit. For extractor operation, connect the other end of the exhaust pipe to the home discharge device. For filter operation, fix the deflector F to the flue support bracket G and connect the other end of the exhaust pipe to the deflector collar F. Make all necessary electrical connections. Apply the flues and fix them with two 2 screws (12a) to the flue support bracket "G" (12b). Slide the bottom section of the flue all the way over the extraction unit until it engages the seat above the hood. Refit the grease filter/s and check for correct hood operation. 5019 318 33259 D GB F NL E P I GR Fig. 1 1. Control panel Grease filter Grease filter release handle Halogen lamps Steam deflector Telescopic flue Side air outlets (for filter version only) Fig. 1 Control panel 1. Timer button The timer can be adjusted with increases or decreases of 1 minute, the default timer setting is 10 minutes. The timer can be set from a minimum of 1 to a maximum of 20 minutes. Within 5 seconds of pressing the "TIMER" button the system switches to setting mode, allowing the user to set the timer using the "-" and "+" buttons. If no setting is made within 5 seconds of choosing the Timer function or setting the time, the countdown starts. The timer countdown can be activated in the following way: - after pressing the TIMER button once (timer default setting); - press the TIMER button again within 5 seconds of setting the desired countdown time. Once the countdown has started, the timer can be cancelled by pressing the TIMER button. Display Shows whether the hood is on/off. "-" Speed decrease / motor OFF button To switch the hood off, press the "-" button to decrease the speed until the motor switches off. "+" Speed increase / motor ON button To switch the hood on, press the "+" button: the motor switches on at the 1st speed. The speed sequence is 1-2-3-4, so with each successive touch of the button "+" the motor steps up to the next speed. If the motor is already at the 4th speed, a beep sounds when the "+" button is pressed. 4th speed is the most intensive motor speed and is timer controlled. [. . . ] Do not "flamb" food under the hood. Do not leave pans unattended when frying. Regular cleaning and maintenance is essential to correct functioning and good performance. Never use flammable materials as hoses for extracted air. [. . . ]