User manual WHIRLPOOL AKR 980 EXTRACTOR OR FILTERING HOOD INSTALLATION

[. . . ] Using the template supplied, mark the holes, drill them and insert the rawlplugs, then fit the 2 hooks (if provided) or partly screw in 2 screws in the top holes. Hang the hood and adjust the position using the adjustment screws on the hooks (if provided). Note: The hood MUST be secured with a further 2 screws, to be inserted in the top holes and (if provided) with 2 screws in the bottom holes. Only for some models: mark the bottom holes (and top), remove the hood, drill, insert the rawlplugs (partly screw 2 screws into the top holes). [. . . ] Fitting or replacing the carbon filter (filter hoods only). Change the carbon filter every six months. Fit the filter/s over the motor according to the model: · Align the pins R on the cowl with the slots S, then turn the filter clockwise until it locks in place or · turn the central handle clockwise. Reverse the above procedure to remove the carbon filter. Refit the grease filters. Or 5019 318 33221 SAFEGUARDING THE ENVIRONMENT 1. Packaging Packaging materials are 100% recyclable and are marked with the recycling symbol . Dispose of the appliance in conformity with local environmental regulations. Packaging materials (plastic bags, polystyrene, etc. ) can be dangerous for children and should be kept well out of their reach. Product This appliance is marked in compliance with European Directive 2002/96/EC on Waste Electrical and Electronic Equipment (WEEE). By ensuring that this appliance is scrapped suitably, you can help prevent potentially damaging consequences for the environment and health. The symbol on the appliance or accompanying documentation indicates that this product should not be disposed of as unsorted municipal waste but must be taken to a collection point for the treatment of WEEE. Disposal must be carried out in accordance with local environmental regulations for waste disposal. For further information on the treatment, recovery and recycling of this appliance, contact your competent local authority, the collection service for household waste or the shop where you purchased the appliance. If the hood does not come pre-fitted with a mains plug, fit one that conforms to applicable standards or use a double-pole switch with a minimum breaking gap of 3 mm. Replacement of the power supply cable with power plug or flexible cable may only be carried out by an authorized Service Centre or a qualified electrician. WARNING: Before reconnecting the hood circuit to the mains power supply and checking correct operation, make sure the power cable is correctly fitted and that it was NOT crushed in the housing during installation. Cleaning the hood Warning!Failure to remove oil and grease (at least once a month) could lead to fire. Use a soft cloth with a neutral detergent. Never use abrasive substances or alcohol. Before using the hood Please read these instructions carefully and keep them for future reference, in order to ensure best use of your hood. Packaging materials (plastic bags, polystyrene, etc. ) can be dangerous for children and should be kept well out of their reach. Make sure the hood has not been damaged during transport. Installation, electrical connections and replacement of the power cable with a plug or new flexible cable must be carried out by a qualified technician in compliance with local safety regulations. This appliance is designed to be used only by adults. Declaration of conformity PRECAUTIONS AND GENERAL RECOMMENDATIONS WARNING! The appliance is not intended for use by young children or infirm persons without supervision. [. . . ] Switch the hood off and then on again to check if the problem has gone. If the problem persists, contact the After-sales Service. Specify: · the nature of the problem, · the model of hood, stated on the data plate inside the hood, accessible by removing the grease filters. · your full address, · your telephone number and area code. [. . . ]