User manual WHIRLPOOL AKT 155/IX INSTRUCTION FOR USE

[. . . ] • Position the 4 clips (A), if not already fitted, around the hob frame, in the slots provided, see Fig. • Measure the centre of the vertical sides of the cut-out as shown in Fig. • Position the centre of the brackets (C) on the centre of the side previously identified. • The upper edge of the brackets must be flush with the worktop surface. [. . . ] Disposal must be carried out in accordance with local environmental regulations for waste disposal. For more detailed information about treatment, recovery and recycling of this product, please contact your local authority, the household waste disposal service or the shop where you purchased the product. Declaration of conformity • This cooktop is suitable for contact with foodstuffs and complies with EEC (EC) Regulation n. • The appliances are designed solely for use as cooking appliances. for room heating) is considered as improper use and potentially dangerous. • The appliances are designed, built and sold in compliance with: • safety objectives of the “Low Voltage” Directive 2006/95/EC (which replaces 73/23/EEC and subsequent amendments); • protection requirements of the EMC Directive 2004/108/EC “Electromagnetic compatibility”; • the requirements of Directive 93/68/EEC 72 PRECAUTIONS AND GENERAL ADVICE CAUTION: During use, accessible parts may become very hot. Keep children away from the appliance in order to avoid the risk of scalding and burns. This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities or lack of experience and knowledge unless they have been given initial supervision or instruction concerning use of the appliance by a person responsible for their safety. • Make sure children do not play with the appliance. • Before any maintenance on the appliance, disconnect it from the electrical power supply. • Keep children away from the appliances when in use and when just switched off. • The appliances must be repaired or adjusted exclusively by a qualified technician. • Make sure that the electrical wires of other electrical appliances near the hob do not come into contact with hot parts. • Do not switch on the hotplates/cooking zones when there is no pan in position. • Never clean the appliance with high pressure water or steam cleaning equipment. • If liquid spills or boils over, the hob may switch off automatically: to enable it to be switched back on again, carefully dry the controls zone. • The hob features different size hotplates/ cooking zones. Use pots whose base diameter is the same as that of the hotplate/cooking zone. • To avoid permanently damaging the glass ceramic hob, do not use: - pots with bottoms that are not perfectly flat; - metal pots with enamelled bottom • When finished cooking, press button . [. . . ] The display shows the code “F21”. • • 1. Important!If you are not able to turn the glass ceramic hob off after using it, disconnect it immediately from the power supply. 2. 74 AFTER-SALES SERVICE Before contacting After-sales Service 1. Try to solve the problem (see “Troubleshooting Guide”). Turn off the appliance and switch it back on again to see if the fault persists. [. . . ]