User manual WHIRLPOOL AMD 063 INSTRUCTION FOR USE

[. . . ] INSTRUCTIONS FOR USE MULTI SPLIT AIR CONDITIONER WITH GAS R410a PRECAUTIONS FOR USE SPECIFICATIONS AND TECHNICAL DATA INSTRUCTIONS FOR USE HOW TO USE REMOTE CONTROL CLEANING AND MAINTENANCE TROUBLESHOOTING INSTALLATION SERVICE - PRECAUTIONS ON INSTALLATION ELECTRICAL SAFETY REQUIREMENTS INSTALLATION DIMENSION DRAWINGS INSTALLING INDOOR UNIT CHECKS AND TEST RUN AFTER INSTALLATION ELECTRICAL CONNECTION Thank you for selecting a Whirlpool air conditioner. For best results, please keep this Manual properly for future reference. This appliance is marked according to the European directive 2002/96/EC on Waste Electrical and Electronic Equipment (WEEE). By ensuring this product is disposed of correctly, you will help prevent potential negative consequences for the environment and human health, which could otherwise be caused by inappropriate waste handling of this product. [. . . ] If the outdoor unit is rusted, paint on the rusty spots to prevent expansion. Outdoor unit Use suitable instruments for the refrigerant R410a. Do not use any other refrigerant than R410a. Do not use mineral oils to clean the unit. 35 TROUBLESHOOTING Indoor unit Warning: Do not attempt to repair the air conditioner yourself. Incorrect repairs may cause electrocution or fire, so please contact the Whirlpool Authorized Service Centre nearest you for professional repairs. The following checks may save your time and costs. Malfunction Cause Air conditioner does not start • To protect the air conditioner when started after a stop, the microcomputer control delays for 3 minutes before allowing the immediately after a stop. An unpleasant odour is • The air conditioner itself is odourless. Any odour is accumulated from the environment. The solution is to clean the air filter perceived at start-up (see page 34). • If there is still any problem, the air conditioner should be cleaned (Please contact the Whirlpool Authorized Service Centre). You may hear a “gurgling” noise • When the air conditioner is started, or the compressor starts or stops while running, or the air conditioner is stopped, you may when the air conditioner is on hear a gurgling noise that is the refrigerant flowing back and is not a malfunction. A thin fog may flow from the • This may occur when the indoor temperature and humidity are high. This is because the indoor air is cooled quickly. outlet when the air conditioner is running in cooling mode. • After a short time, the fog will disappear as the indoor temperature and humidity decrease You may hear a slight crack when • This is the sound of friction caused by expansion of the front panel or other parts due to the change of temperature the air conditioner is started or stopped Air conditioner does not run. • Is the power plug loose in the socket?• Has the circuit protection device been tripped?• Is the voltage too high or too low?(see page 39 - have it tested by a professional). • Has the timer function been used correctly?(see page 31) The air conditioner is not cooling • Is the temperature setting correct?(see page 32) (or heating) properly • Is the air intake or outlet of the outdoor unit blocked? [. . . ] Replace and tighten all the caps on the valves. Diameter (mm) Ø6 Ø 9. 5 Ø 12 Ø 16 Ø 19 Twisting moment (Nm) 15~20 35~40 45~50 60~65 70~75 INDOOR UNIT Refrigerant fluid direction of flow Vacuum pump 2-way valve (6) Open by 1/4 turn (7) Turn to open fully 3-way valve Service inlet (2) Turn (8) Secure (7) Turn to open fully (2) Turn (8) Secure Valve cap (2) Turn (8) Secure Connect to the indoor unit 12K MODE: Conversion joint INSTALLATION DIMENSION DIAGRAM The installation must be done by trained and qualified service personnel with reliability according to this manual. • Contact service centre before installation to avoid the malfunction due to unprofessional installation. • When picking up and moving the units, you must be guided by trained and qualified person. • Ensure that the recommended space is left around the appliance. 44 CHECKS AND TEST RUN AFTER INSTALLATION Check Items After Installation Check items Is the installation secure? [. . . ]