User manual WHIRLPOOL ARG 316/A-LH PRODUCT FICHE

[. . . ] • The appliance is built with reusable material. When scrapping, follow the local environment protection disposal regulations. To avoid the risk of children being trapped and therefore Declaration of conformity • This appliance is designed to store food and is manufactured in conformity with EEC directive No. • This appliance has been designed, built, and marketed in compliance with: suffocating, do not allow them to play or hide inside the refrigerator. [. . . ] You do not need to apply a lot of pressure to the lever in order to activate the ice dispenser. Pressing hard will not make the ice dispenser faster or in greater quantities. Remove the glass to stop dispensing. For cubed ice For crushed ice NOTE: The first few batches of ice cubes may have an off-taste. Ice is dispensed from the ice maker bin in the freezer compartment. When the outside dispenser bar is pressed, a trapdoor opens between the ice bin and the dispenser. When the glass is taken away from the dispenser bar, a buzzing sound may be heard for a few seconds as the trapdoor closes. The dispenser will not operate when the freezer compartment door is open. Large amounts of ice cubes should be taken directly from the bin, not through the dispenser. For crushed ice, cubes are crushed before being dispensed. This may cause a slight delay in dispensing crushed ice. Noise from the ice crusher is normal, and pieces of ice may vary in size. Use warm water to melt the ice if necessary. Never use anything sharp to break up the ice in the bin or bucket. This can cause damage to the ice container and the dispenser mechanism. 2. Wash ice bin or bucket with a mild detergent, rinse well and dry thoroughly. Do not use harsh or abrasive cleaners or solvents. Style I Style II 48 3gb33001. fm5 Page 49 Monday, August 20, 2001 3:48 PM Removing the ice maker bin Remove, empty, and clean the bin: • if the ice dispenser has not been or will not be used for a week or more; • if a power failure causes ice in the bin to melt and freeze together; • if the ice dispenser is not used regularly. To remove the bin 1. Pull the covering panel out from the bottom and slide it to the rear. 2. Lift the signal arm to the OFF position. Ice can still be dispensed, but no more will be made. 3. Lift the front of the bin and pull it out. Use warm or lukewarm water to melt the ice if necessary. Do not use sharp tools to break up the ice in the bin. This can damage the bin and the dispenser mechanism. [. . . ] Ordering replacement filters To order more water filter cartridges, please contact your authorized Whirlpool dealer. WATER CONNECTION (FOR ALL MODELS GREATER THAN 60 cm DEEP) • We recommend that installation is carried out by a qualified plumber or by the After-sales Service nearest to the sales outlet where the appliance was purchased. • Disconnect the electrical supply to the refrigerator prior to installing the ice maker water line. • The appliance is supplied with 2 metres of coiled water tubing for connecting the ice maker to the water supply. • First remove the protective rubber cap, then connect the smallest end of the coiled tubing (1) to the water connector(2). [. . . ]