User manual WHIRLPOOL AVM 350/WP/WH INSTRUCTION FOR USE

[. . . ] When the temperature returns to within normal levels the hob is able to be switched on again. Make sure the cooking zones and the bottoms of pots are dry before use. Do not place metal objects such as kitchen utensils (knives, forks, spoons, …), lids or other similar items on the cooking zones as they can become very hot. Be extremely vigilant when cooking food with boiling oil or fat since these can catch fire. [. . . ] To guarantee correct operation, the appliance must be installed on a perfectly flat surface. For cut-out dimensions, see the figure below. domino 300 288 The worktop must be 20-50mm thick. If necessary, cut the kitchen unit and worktop to fit before installing the hob. Clean the cutout of any chips that could compromise appliance operation. 8 +2 0 +2 0 490 350 Dimensions in mm For the distance between the underside of the induction hob and the kitchen unit (or separating panel), observe the dimensions given in the figure at the side. 5 To guarantee correct operation, the appliance must be installed on a perfectly flat surface. If necessary, cut the kitchen unit and worktop to fit before installing the hob. Clean the cutout of any remaining dust that could compromise appliance operation. Is installed adjacent to the hob, leave a distance of at least 100 mm from the edge of the hob. Position the clips (A) in the spaces provided on the hob trim (fig. After 10 minutes' use of the booster function, the appliance automatically sets the zone to level 9. Switching off cooking zones Select the cooking zone to be switched off by pressing the “+” or “-” key (a dot lights up at the bottom right hand side of the heat setting indicator). Press the key “-” to set the level to “0”. The cooking zone can also be switched off by pressing keys “+” and “-” at the same time. The cooking zone switches off and the residual heat indicator “H” lights up Minute minder The minute minder can only be used when the hob is not in use and allows a maximum setting of 99 min. Press the button “+” below the timer indicators: the display shows the minutes for setting. Select the time desired using the buttons + and -. After a few seconds the minute minder starts to count down. Once the set time has elapsed an acoustic signal sounds. Child lock This function locks the hob controls to prevent accidental switching on by children. To activate the child lock function, switch on the hob then press and hold the button for three seconds: an acoustic signal and a luminous indicator under the key symbol signal activation. [. . . ] The timer function can only be used with one cooking zone at a time. Fm Page 16 Wednesday, June 22, 2011 10:28 AM MAINTENANCE Care and maintenance Clean the hob after each use in order to avoid damaging the surface and to prevent the formation of baked-on deposits which are difficult to remove. Before cleaning, make sure the cooking zones are switched off and that the residual heat indicator (“H”) is not displayed. € Never clean the hob with a steam cleaner! [. . . ]