User manual WHIRLPOOL AWE7125

[. . . ] Refreshes briefly worn outer clothing made of cotton, artificial fibers and blends with cotton. Use lovest recommended detergent amount. Woollens, labelled with the Woolmark and identified as machine washable, as well as textiles made of silk, linen, wool and viscose marked as handwashable Normally soiled cotton laundry. Most favourable programme in terms of combined water and energy consumption for washing cotton laundry. [. . . ] To cancel the “Start delay” . . before you press the “Start/Pause” button: • Turn the programme selector to another position or press the “Reset” button. . . after having pressed the “Start/Pause” button: • Press the “Reset” button for at least 3 second. The start delay indicator light goes off. PROGRAMME START Open the tap and press the “Start/Pause” button. The indication lamp next to the “Start/Pause” button lights up. The programme sequence indicator shows the current programme phase, running from left to right through Wash, Rinse, Spin/Drain. When the programme phase is finised, the corresponding indication goes out. • Note: If there is a power interruption or if the appliance is disconnected during the cycle, the programme will run again from the point where it was interrupted. “LID OPEN” INDICATION Before starting and after end of a programme, the lamp lights to show the the lid can be opened. As long as a wash programme is running, the lid remains locked and must on no account be forced open. In case you have an urgent need to open it during a running programme, refer to “Cancel a running programme before the end”. FAILURE INDICATIONS In case of any failures or irregularities, consult the “Troubleshooting Guide” in your Instructions for Use. “Water tap closed” No or not sufficient inlet water. “Service” Failure or malfunction of an electrical component. “Clean pump” Waste water is not pumped out. PROGRAMME END • The “Lid open” indicator lights up, and the display shows “End”. After about a quarter of an hour, the washing machine will switch off completely to save energy. 1. Turn the programme selector to the “Off/O” position. 3. Open lid and drum and unload the machine. 4. Leave the lid open for some time to allow the interior of the machine to dry. CHANGE PROGRAMME AND/OR OPTIONS AFTER PROGRAMME START • Press the “Start/Pause” button to pause the programme. • Select the new programme, temperature, any options and another spin speed if you want. • Press the “Start/Pause” button again. [. . . ] Chlorine or perborate bleaches must not be used!“Rapid” button • Enables quicker washing by shortening the programme duration. • Recommendable for small loads or only lightly soiled laundry. “Prewash” button • Only for heavily soiled loads (for example sand, granular dirt). [. . . ]