User manual WHIRLPOOL AWG 5104C PRODUCT FICHE

[. . . ] Do not plug the power supply with wet hands. Never touch the machine with wet hands or feet. Never open the detergent drawer while the device is running. Never force to open the door of the machine while the machine is running. [. . . ] The softeners with high density should be diluted with some water before filling in the drawer. That is because the softener with high density obstructs the siphon and prevents the flow of the softener. 12 You can use fluid detergents in all programs without pre-washing. For this, mount the fluid detergent level plate in the second compartment of the detergent drawer and arrange the amount of fluid detergent according to the levels on this plate. RUNNING THE MACHINE Program selection and features Select programmes and additional functions appropriate for your laundry with the help of the tables shown on pages 17. Start/Pause button Pressing this button you can start the programme you selected or put the programme in progress on pause. When the programme you selected starts its operation the lamp above the start/pause button will start lighting. When you wish to put the selected programme on pause press the start/pause button once. In order to restart the programme from the point it was put on pause at you will have to press the start/pause button once again. Starting the program Adjust the programme knob to a programme you wish to select. If the programme you selected is a wash programme the wash operation lamp will flash. If the programme you selected is a rinse/spin or drain programme the lamps indicating the related selection will flash. Start the selected programme by pressing the start/pause button. When you start the programme by pressing the start/pause button the lamps will light up indicating that the start/pause button is active and the wash operation is in progress. 13 Selecting an additional function button Adjust the programme button to a programme you wish to select. Dry Load Capacity (kg) Type of Laundry Explanations 1- COTTON 90° 2- COTTON 60° WITH PREWASH *3- COTTON 60° 5 5 5 Dirty, boil, cotton and linen textile Very dirty, cotton, coloured and linen textile Dirty, cotton, coloured and linen textile Slightly dirty, paint to get out, cotton, coloured and linen textile Dirty, synthetic or synthetic mixture textile Tulle and curtain as sensitive laundry Slightly dirty, synthetic or synthetic mixture textile Slightly dirty, synthetic or synthetic mixture textile Dirty, hand and machine to wash wool laundry Dirty, hand and machine to wash wool laundry Very slightly dirty, cold water, hand and machine to wash wool laundry Slightly dirty, cotton, coloured and linen textile Underwears, sheet, table cloth, t-shirt, shirt, towel 4- COTTON 40° 2 5 5- SYNTHETICS 60° 6- SYNTHETICS 40° WITH PREWASH 7- SYNTHETICS 40° 8- SYNTHETICS 30° 9-DELICATES 40° 2 1+2 2 2 2 3 3 3 3 2 Nylon socks, blouse 17 10-HAND WASH / WOOL 30° 11-WOOL COLD 2 2 All wool laundry 2 2 12-QUICK WASH 30° 2 2, 5 Underwears, sheet, table cloth, t-shirt, shirt, towel RINSE When you need an additional rinsing to be done to your clothes after the washing process, you can use this program for all kinds of clothes. You can use this program, when you need an additional spinning to be done to your clothes after the washing process. After thoroughly drying the drawer put it back in its place reversing the removal procedure. DIAGRAM-1 19 DIAGRAM-2 SIPHON PLUG Pull out the detergent drawer. Remove the siphon plug and clean the residues of the softener thoroughly. Fit the cleaned siphon plug in its location. Check if it placed properly. Siphon plug THE CABINET To clean the outside of the appliance, use a neutral detergent and a damp cloth. Please be careful not to use material that could damage the exterior surface of your machine. WARNING! If the machine is installed in a location where the ambient temperature can fall below 0 C, do the following when it will not be in use: Plug in the machine. Close the water tap and pull out the water inlet hose or hoses from the tap. Place the ends of the water drain and water inlet hoses in a cup on the ground. Adjust the program knob to “Draining” program. Run the program by pressing the start/pause button. Unplug your machine when the program is over (program end light is on). When you complete these proces, the remaining water inside the machine will be drained and thus formation of ice in the machine will be prevented. [. . . ] Press the start/pause button. In order to stop the foam, dilute one table-spoon of softener in half liter of water and pour it in the detergent drawer. Press the start/pause button after 5-10 minutes. Arrange the amount of the detergent properly in the next washing process. Use only the detergents produced for full automatic machines. (see Table-1) Use more detergent according to the detergent. Wrong detergent has been used. The washing result is bad. Your laundry too dirty for the program you have selected. The amount of detergent used is not sufficient. 24 FAILURE PROBABLE CAUSE Clothes exceeding the maximum capacity has been filled in your machine. The washing result is not good. Your water may be hard. [. . . ]