User manual WHIRLPOOL AWL 200 INSTRUCTION FOR USE

[. . . ] Packaging material The packaging material can be 100% recycled, as confirmed by the recycling symbol ( ). Dryer The dryer is built from recyclable materials. If you decide to scrap the dryer act responsibly and observe local waste disposal by laws. Cut off the power cord so that the dryer cannot be connected to the mains. PRECAUTIONS Child safety • After use, set the programme selector to position “0”. [. . . ] Close the door and press the Start button again to continue the count-down. To cancel the count-down turn Start delay selector to “0”. Suitable for delicate articles. Buzzer Pressing the button initiates a buzzer sound to signal at regular intervals, at the end of the drying cycle. Additional Programme Airing The laundry will be aired during 20 minutes without heating. STARTING AND COMPLETING THE PROGRAMME 1. Having selected the desired drying time or programme and options, press the Start button. If selected a buzzer sounds to signal the end of the drying cycle. It will sound at regular intervals for some time. If you do not unload the laundry at the end of the drying cycle, an automatic anti-crease cycle ( ) will operate for maximum 20 minutes (Time-steered dryer) or 70 minutes (Electronic dryer): the drum rotates at regular intervals preventing the laundry from creasing. On completion of the programme, set the programme selector knob to position “0”. The “Machine On” light goes off. Clean the lint filter at the end of each drying cycle. If you change the programme (Electronic dryer) during the drying cycle the dryer stops. To operate the new programme press the Start button again. 39 Interruption of the drying cycle To interrupt the dryer during the drying cycle, set the programme selector knob to position ( ) Airing and press the Start button again for the Electronic dryer. Wait at least 5 minutes before opening the door to allow the dryer to cool down. For your safety the programme stops automatically if you open the door. To restart close the door and press the Start button again. INSTALLATION • • • • Install your dryer in a room which is not subject to extreme conditions. Remove the protective foil from the control panel. Level the dryer adjusting the 2 feet at the front. Take care not to trap the mains cable between the dryer and the wall. Stacking kit Your dryer can be stacked on top of your washing machine, using the stacking kit AMH 542, which is available from your dealer. Minimum housing dimensions: Width: 600mm Height: 850mm Depth: 560mm ELECTRICAL CONNECTION • • • • • • The electrical connection has to be carried out in compliance with local regulations. Information on the voltage is given on the rating plate on the back of the dryer. [. . . ] To remove the door lock: • Press the hook at the upper part down with a screwdriver, pull it forward and take the lock system out. To change the door opening: • Turn the door. • Re-fit the door with the 2 screws at the preferred position. • Hang the door lock system at the opposite side of the door and latch it. [. . . ]