User manual WHIRLPOOL AWM 8102/1 PROGRAM CHART

[. . . ] Only woollens with a felt-free finish, labelled with the woolmark and identified as machine washable. If you select “Rinse Hold” do not leave items to soak for too long. Textiles made of silk, linen, wool and viscose marked as “handwashable”. If you select “Rinse Hold” do not leave items to soak for too long. [. . . ] **To reduce the water temperature, some cold water is added at the end of the main wash cycle, before the pump drains the water out. Note: The programme stops to “Rinse Hold” at the time the “Rinse Hold” light in the programme flow indication is on. Terminate the “Rinse Hold” option: • Press the “Rinse Hold” button again; the programme will terminate automatically with the final spin cycle for the present wash programme. • If you do not wish to spin the clothes, turn the programme selector knob to the “Drain” programme and press the “Start/Pause” button again when flashing. “Easy Ironing” button • Can be used together with Cotton and Synthetics programmes to make ironing easier. • Increases the water quantity and the clothes are spun very soft. “Spin Speed Reduction” button • Every programme has an automatic predefined maximum spin speed. • Press the button to set another spin speed. • If the spin speed “0” is selected, the final spinning is cancelled but intermediate spin peaks remain during rinse. PROGRAMME START Open the tap and press the “Start/Pause” button. The pilot lamp of the “Start/Pause” button lights up. The indicator lamps show the sequence reached in the programme. After starting the programme, the sequence indication runs from left to right through Wash, Rinse, Spin. When the sequence of the programme is finished the corresponding lamp goes out. DOOR LOCK The door can be opened when the “Door Open” indication is on. PROGRAMME END • The remaining time is on “0:00” and all the lights of the programme sequence indication are off. Turn the programme selector to the “ ” position. Close the tap and leave the door ajar to allow the drum to dry out. CHANGE THE PROGRAMME, TEMPERATURE, OPTIONS AFTER PROGRAMME START 1. Press the “Start/Pause” button to pause the programme. Select the new programme (with temperature), any options and another spin speed if you want. Press the “Start/Pause” button again. [. . . ] When the combination of programme, additional options and temperature is not possible, the indication lights switch off automatically. Unsuitable combinations of options are deselected automatically. “Eco Wash” button • The duration of the wash is extended and the temperature reduced to save up to 40% of energy but maintaining good washing results. “Prewash” button • Only for heavily soiled loads (for example sand, granular dirt) sensible. The cycle time increases approximately 15 min. [. . . ]