User manual WHIRLPOOL AWM 9110 BS INSTRUCTION FOR USE

[. . . ] DEFINITION OF USE This appliance is exclusively destined to wash and spin machine washable laundry. • Observe the instructions given in these Instructions for Use and in the separate Programme Chart when using the washing machine. • Keep these Instructions for Use and the Programme Chart; if you pass on the washing machine to another person, also give him/her the Instructions for Use and the Programme Chart. BEFORE USING THE WASHING MACHINE 1. Remove the packaging and check • After unpacking, make sure that the washing machine is undamaged. If in doubt, do not use the washing machine. [. . . ] • If you use descaling agents, dyes or bleaches, make sure they are suitable for washing machine use. Descaler could contain components that can damage parts of your washing machine. • Do not use solvents (turpentine, benzine, etc. ) Do not machine wash fabrics that have been treated with solvents or flammable fluids. • You can use liquid detergent in the “Prewash” phase for programmes with this option. In this case put only powder detergents in the compartment for the main wash . • When using concentrated fabric softeners, dilute with water in the detergent dispenser up to “MAX” level mark. • To prevent dispensing problems when using highly concentrated powder and liquid detergents, use the special detergent ball or bag supplied with the detergent and place it directly inside the drum. If you use gel-type detergent, please use the powder detergent insert setting. • For “Start delay”, only use powder detergent. Powder detergent remains in the detergent dispenser until the programme starts, but liquid detergents might run out of the detergent dispenser. • If you use powder starch, observe the starch manufacturer’s information and proceed as follows: 1. Wash your laundry using the desired wash programme. Next mix the starch according to the starch manufacturer’s instructions. Set the “Rinse and Spin” programme, reduce the spin speed to maximum 800 rpm and start the programme. Pull the detergent dispenser out until you can see about 3 cm of the main wash chamber 5. While the water is running into the detergent dispenser, pour the starch solution into the main wash chamber . If there are starch residues in the detergent dispenser after the end of the programme, clean it (see “Care And Maintenance”). DRAINING RESIDUAL WATER Residual water should be removed: • before moving a washing machine (relocation), • when installing in areas prone to frost and • before removing the filter. 1. Before emptying the residual water, switch the appliance off and unplug it from the mains socket. Make sure that the water has cooled before draining. 2. Turn the slot through 180° by means of a coin, so that the dot points to the open lock. 3. Remove the hose, place a low container underneath and pull the cap from the hose. 4. Drain the residual water until no more flows out. [. . . ] Water enters into the washing machine’s Aquastop tray An audible tone sounds; the pump is active. Switch off the washing machine by pressing “On/ Off”, unplug it and close the water tap. Inform After-Sales Service and describe the fault (see “After-Sales Service”). Failure of electrical component • Press and hold “Reset/Drain” for a few seconds. [. . . ]