User manual WHIRLPOOL AWM 9150 PROGRAM CHART

[. . . ] Use Stain Treat option for optimal removal of organic stains like blood, egg yolk etc. 10. 0 ❉ ❉ ❉ ❉ Yes Yes ❉ ❉ ❉ ❉ ❉ ❉ ❉ ❉ ❉ ❉ ❉ ❉ ❉ ❉ extra high extra high extra high extra hot/cold hot/cold White Cotton 10. 0 Stain Cycle 10. 0 ❉ ❉ Yes ❉ ❉ ❉ ❉ ❉ ❉ ❉ hot/cold Normal Cotton For cotton loads such as shirts, permanent press blends and linen items. 10. 0 ❉ ❉ Yes ❉ ❉ ❉ ❉ ❉ ❉ ❉ high hot/cold Rapid Wash For slightly soiled overalls and sports wear made of cotton, polyester, polyamide and blends with cotton. For no-iron fabrics such as sport shirts, permanent press blends, cotton and linens. Check care label instructions to make sure that garment is identified as machine washable. For curtains, delicate dresses, skirts, shirts and blouses. [. . . ] • Check the programme setting and press and hold the “Start” button. Prewash cycle increases programme duration approximately 15 min. Consumption values were measured in normalized conditions in compliance with Standard IEC 60 456. Consumption data in the home may vary with respect to the values in the table dependent on the water supply pressure and temperature, the load and the type of wash. * The remaining time indicator can similarly deviate from the values in the table, because it takes into account the household conditions applicable at that time. The Hygiene Plus cycle complies to the UK Care Standard Act 2000 (CSA) Standard 26, therefore rest time indication might vary if hot water supply is below 60°C. ** When tested to 5/N25 2040 2:2000. ADD DETERGENT, CLOSE THE DOOR AND SELECT THE PROGRAMME Add the detergent as described in the programme table or in the chapter “Detergent and Additives” of the instructions for use. The remaining time display shows the duration of the chosen programme (in hours and minutes) and the pilot lamp of the wash cycle button lights up. The programme sequence, the predefined spin speed, water temperature, End of Cycle signal and options indicators corresponding to the selected programme light up. The recommendations can be altered by pressing the modifier and the options buttons. SELECT ANY DESIRED OPTION AND MODIFIER Selecting any option the indication lights up. When the combination of programme, additional options and modifiers is not possible, the indication lights switch off automatically and a signal sounds. “Prewash” • For heavily soiled laundry. • Add detergent to the Prewash and Main Wash dispenser compartments. • When using the Prewash compartment, do not use liquid detergent in the Main Wash compartment: use powder detergent for the main wash cycle. • “Prewash” and “Auto Soak” options cannot be selected in the same cycle. “Stain Treat” • For heavily soiled laundry. • Warm water fill for optimal organic soil removal and heat to high temperature. “Auto Soak” • For heavily soiled laundry with set-in stains. • Use with a wash cycle: Select the desired wash cycle and “Auto Soak” option, add detergent to the Prewash and the Main Wash dispenser compartments; press the “Start” button. When using the Prewash compartment, do not use liquid detergent in the Main Wash compartment: use powder detergent for the main wash cycle. • Use without a wash cycle: Select first “Drain/Spin” or “Rinse/Spin” and then “Auto Soak” option; choose the desired soak temperature, add detergent to the Prewash compartment and press the “Start” button. • “Prewash” and “Auto Soak” options cannot be selected in the same cycle. “2nd Rinse” • This option is recommended to ensure the removal of detergent or bleach residues from garments. • It provides an additional rinse with the same water temperature as the first rinse. [. . . ] Close the door and press the “Start” button again. The programme will run again from the point where it was interrupted. 5019 301 15131 Black process 45. 0° 100. 0 LPI 30115131GB. fm Page 3 Thursday, November 4, 2004 4:58 PM HOT / COLD FILL INSTRUCTION Connect hot and cold water supply (Fig. 1): 1. Fix the water inlet hose with the red stripe at the red valve of the washing machine and at the hot water tap. Fix the water inlet hose with the blue stripe at the white valve of the washing machine and at the cold water tap. [. . . ]