User manual WHIRLPOOL AWO 7666 INSTRUCTION FOR USE

[. . . ] Make sure to wash only similar colours together in one wash load. Yes max. Shortly worn clothing made of cotton, polyester, polyamide and blends with cotton. Brief programme to refresh your laundry. Textiles made of wool, linen, viscose or silk (respect care label!) marked as hand-washable or machine-washable. This programme, at 40° C, is tested and approved by the Woolmark Company for machine- and handwashable wool textiles which are labelled with the Woolmark. [. . . ] The programme duration may differ from the values indicated above as it depends on the operation conditions applicable at that time (see also “Troubleshooting Guide” in your Instructions for Use). * ** *** Reference programmes for Energy Label. To reduce the water temperature, some cold water is added at the end of the main wash cycle before the water is drained. Automatic adaptation of programme duration after detection of wash load. Press the “Start/Pause” button ; the programme will terminate automatically with the final spin cycle for the present wash programme. If you do not wish to spin the clothes, turn the programme selector to the “Drain” programme and press the “Start/ Pause” button to start draining. FAILURE INDICATORS If one of the failure indicators blinks, consult the “Troubleshooting Guide” in your Instructions for Use. “Water tap closed”: no or not sufficient inlet water. “Service”: failure or malfunction of an electrical component. “Clean pump”: waste water is not pumped out. Spin speed on display blinks: unbalance during spinning. “Spin” button • • Every programme has a predefined spin speed; press the button if you want to set a different spin speed. If spin speed “0” is selected, the final spinning is cancelled and the water is drained out only. However, intermediate spin phases remain during rinse. PROGRAMME END • 1. The “Door open” indicator lights up, and the display shows “End”. Turn the programme selector to the “Off/O” position. Leave the door ajar to allow the drum to dry. LOAD LAUNDRY, ADD DETERGENT AND SELECT THE PROGRAMME Load the laundry, close the door and add detergent as indicated on the front page and as described in the chapter “Detergent and Additives” in your Instructions for Use. Turn the programme selector to the desired programme and temperature. The display shows the programme duration and the predefined spin speed. The “Start/Pause” indicator blinks. • • • • SELECT ANY DESIRED OPTION Push the button of any option desired - the indicator lights up. If the combination programme/option or option/option is not possible, the indicator switches off automatically. “Prewash” button • • • Adds a prewash cycle to the wash programme selected; prolongs the programme by about a quarter of an hour. Recommended for heavily soiled laundry (e. g. Do not use liquid detergent for the main wash when selecting “Prewash”. additive’s efficiency to get better wash performance and stain removal. Add an appropriate amount of in-wash additive for stain removal (powder) to the main wash chamber, together with your detergent (only use powder detergent with this option). [. . . ] Recommendable for lightly soiled laundry without stains. Make sure that your detergent is suitable for cold wash temperatures (15 or 20 °C). Mainly selectable on the lowest temperature step of the programmes. RESET A RUNNING PROGRAMME BEFORE THE END The “Reset” button cancels a programme before the end. • Press and hold the “Reset” button for a few seconds. [. . . ]