User manual WHIRLPOOL AWO/C 72200 PRODUCT FICHE

[. . . ] Shortly worn outer clothing made of cotton, polyester, polyamide and blends with cotton. Only woollens labelled with the woolmark and identified as machine washable. This programme (40°) is tested and approved by The Woolmark Company for machine washable wool. Textiles made of linen, silk, wool and viscose marked as “handwashable”. [. . . ] • If you do not wish to spin the clothes, turn the programme selector knob to the “Drain” programme and press the “Start/Pause” button. “Variable spin” button • Every programme has a predefined spin speed. • Press the button to set another spin speed. • If spin speed “0” is selected, the final spinning is cancelled but intermediate spin peaks remain during rinse. START DELAY The “Start delay” allows to run the machine at the consumer’s convenience, for example at night when electricity is cheaper. Do not use liquid detergent when activating “Start delay” option. • Select programme, temperature and options. • Press the “Start delay” button to select the delay time by 1 to 23 hours. • Press the “Start/Pause” button. The countdown of the delay time begins; the “Start delay” indication lamp and the dot on the display will keep blinking until the programme starts. • The time delay indication disappears when the programme starts and it is replaced by the remaining programme time. Select the new programme (with temperature), any options and another spin speed if you want. Press the “Start/Pause” button again. The new programme continues at the same position where the previous programme was interrupted. Do not add detergent for this programme. CANCEL (RESET) A RUNNING PROGRAMME BEFORE THE END The “Reset” button cancels a programme before the end. • Press the “Reset” button for at least 3 seconds. Any existing water is drained out before the door can be opened. Consumption values were measured in normalized conditions in compliance with standard IEC/EN 60 456. Consumption data in the home may vary with respect to the values in the table in relation to the water supply pressure and temperature, the load and the type of wash. * The remaining time indicator can deviate from the values in the table, because it takes into account the household conditions applicable at that time. ** To reduce the water temperature, some cold water is added at the end of the main wash cycle, before the pump drains the water out. *** Reference Programme for Energy Label. ADD DETERGENTS, CLOSE THE DOOR AND SELECT THE PROGRAMME Add detergents as indicated on the front page and as described in the chapter “Detergent and Additives” in your Instructions for Use. [. . . ] • Appropriate for use of stain removers and bleaches on oxygen basis. Chlorine or perborate bleaches must not be used!“Prewash” button • Only for heavily soiled loads (for example sand, granular dirt) sensible. Increases the cycle time by approximately 15 min. [. . . ]