User manual WHIRLPOOL AWO/D 7308 W PRODUCT FICHE

[. . . ] Alternative method of terminating — programme after “Rinse Hold”. Press “Reset/Drain” and then “Start/Pause” to start the “Drain” programme. ❉: 1) 2) 3) optional / Yes : dosing required For improved garment care, spin speed is restricted in these programmes. Do not use liquid detergent when activating the “Start Delay”. Do not use liquid detergent for the main wash when activating the “Prewash” option. The wool and handwash cycles of this machine have been tested and approved by The Woolmark Company for the washing of Woolmark garments labelled as “machine wash” or “hand wash” provided that the garments are washed according to the instructions on the garment label and those issued in this programme chart. [. . . ] Next time you want to use your individual programme setting, select the programme, push the “Favourites” button and start by pushing “Start/ . Pause” If you want to replace the saved programme setting by another one: • Push the programme button, select temperature, spin speed and options as desired and then press and hold the “Favourites” button for at least 3 seconds. The previously saved programme setting will be replaced by the new one. START DELAY The “Start Delay” allows to run the machine at the consumer’s convenience, for example at night when electricity is cheaper. • Select programme, temperature, spin speed and options. • Press the “Start Delay” button to select the delay time up to 23 hours. • Press the “Start/Pause” button . The countdown of the delay time begins; the clock symbol next to the delay time and the dot between hours and minutes flash. • The time delay indication disappears when the programme starts and it is replaced by the remaining programme time. • Once having pressed the “Start/Pause” button , the number of hours preselected can be reduced by pressing and holding the “Start Delay” button. From 1 hour on, the delay time can also be reduced by minutes. To reduce the water temperature, some cold water is added at the end of the main wash cycle, before the pump drains the water out. ** *** Reference Programme for Energy Label. ADD DETERGENTS, CLOSE THE DOOR AND SELECT THE PROGRAMME Add detergent as indicated on the front page and as described in the chapter “Detergent and Additives” in your Instructions for Use. The blue light circle signals that the washer is switched on. Select the desired programme by pushing the corresponding programme button; it is marked by a blue light. The temperature and spin speed indicated on the display can be altered by pressing the “Temperature” button or the “Variable spin” button . SELECT ANY DESIRED OPTION When the combination of programme and additional option(s) is not possible, the indication lights switch off automatically. Unsuitable combinations of options are deselected automatically. “Eco” button • With a modified temperature profile and a slightly prolonged washing duration, the optimum combination of excellent washing result and even lower energy consumption is achieved. “Easy ironing” button • Can be used together with “Cotton”, “Synthetics” and “Daily load” programmes to make ironing easier. • Increases the water quantity and the clothes are spun very gently. “Prewash” button • Only for heavily soiled loads (for example sand, granular dirt) sensible. [. . . ] • If you do not wish to spin the clothes, push the “Drain/Reset” button and then the “Start/Pause” button to start the Drain programme. “Variable spin” button • Every programme has a predefined spin speed. • Press the button to set another spin speed. • If spin speed “0” is selected, the final spinning is cancelled but intermediate spin peaks remain during rinse. [. . . ]