User manual WHIRLPOOL AWT 4105 PROGRAM CHART

[. . . ] Normally soiled bed linen, table linen and underwear, towels, shirts etc. Normally to heavily soiled blouses, shirts, overalls etc. made of polyester (Diolen, Trevira), polyamide (Perlon, Nylon) or blends with cotton. [. . . ] Please avoid excessive detergent dosing. Whirlpool is a registered trademark of Whirlpool USA. 5019 312 10458 CONSUMPTION DATA Temperature selector (°C) Cotton Cotton Cotton Synthetic Synthetic Delicate Wool Silk 95 60 40 60 40 40 40 30 Load (kg) 5, 0 5, 0 5, 0 2, 0 2, 0 1, 5 1, 0 1, 0 Water (l) 63* 55 55 56 56 60 60 60 Energy (kWh) 1, 80 0, 95 0, 55 0, 80 0, 40 0, 55 0, 50 0, 30 Programme Approx. Programme Duration (hours : minutes) 2:05 2:05 2:05 1:30 1:30 0:45 0:40 0:50 Appliance in “Rinse Hold”: • Press the “Rinse Hold” button again: the programme will terminate automatically with the selected spin cycle. • If you do not wish to spin the clothes, press the “On/Off” button, turn the programme selector knob to the “Drain” programme and press the “On/Off” button again. PROGRAMME START Turn on the tap and press the “On/Off” button. The indicator light of the “On/Off” button lights up. Note: If there is a power interruption or if the appliance is disconnected during the cycle, the programme will run again from the point where it was interrupted. END OF WASH CYCLE • The programme selector knob is in the Stop position. Press the “On/Off” button to switch off the machine. Wait for the lid to unlock (about 1 minute). Open the lid and the drum doors and unload the machine. Leave the lid open for some time to allow the inside of the appliance to dry. CHANGE THE PROGRAMME DURING THE WASH CYCLE 1. Switch off the machine by pressing the “On/Off” button. Start programme by pressing the “On/Off” button again. PAUSE/INTERRUPT A PROGRAMME If, for any reason, you wish to interrupt the programme for a certain time and continue it later: 1. After the desired pause, press again the “On/Off” button. Switch off the machine by pressing the “On/Off” button. Set the programme selector to “Drain”. Press the “On/Off” button again to start the “Drain” programme. Prewash cycle increases programme duration by approximately 15 min. Consumption values were measured in normalized conditions in compliance with standard IEC/EN 60 456. [. . . ] “Half Load” button • Can be used for small loads and lightly soiled laundry. • Reduces the water consumption especially during the rinse. “Intensive Rinse” button • The amount of water is increased to ensure a more intensive rinse. [. . . ]