User manual WHIRLPOOL AWT 8105 PROGRAM CHART

[. . . ] made of polyester (Diolen, Trevira), polyamide (Perlon, Nylon) or blends with cotton. Slightly soiled overalls and sportswear made of cotton, polyester, polyamide and blends with cotton. Curtains and delicate clothing, dresses, skirts, shirts and blouses. Textiles made of silk, linen, wool and viscose marked as “handwashable”. [. . . ] **To reduce the water temperature, some cold water is added at the end of the main wash cycle, before the pump drains the water out. Note: The programme stops to “Rinse Hold” when the “Rinse Hold” light indicator programme is on during the cycle. Appliance in “Rinse Hold”: • Press the “Rinse Hold” button again: the programme will terminate automatically with the selected spin cycle. • If you do not wish to spin the clothes, turn the programme selector knob to the “Drain” programme and press the “Start/Pause” button again. “Spin Speed Reduction” button • Every programme has an automatically allocated maximum spin speed. • Press the button to set another spin speed. • If the spin speed “0” is selected, the final spin is cancelled, but not the intermediate spins. The programme ends with a drain cycle. DOOR LOCK For safety reasons, the door is locked during certain phases of the cycle. At the end of the cycle or during an interruption, the door unlocks automatically after about 1 minute. END OF WASH CYCLE • The remaining time is on “0: 00” and the “End” lamp lights up. Turn the programme selector to the “ ” position. Open the door and the drum flaps and unload the machine. CHANGE THE PROGRAMME OR OPTIONS DURING THE CYCLE 1. Select the new programme using the programme selector. If necessary, select the additional options and the spin speed. The luminous indicator of the “Start/Pause” button flashes. Note: the “Start Delay” and “Prewash” options cannot be selected after a programme change. Press the “Start/Pause” button. The new programme selected continues at the same position where the previous programme was interrupted. Note: Do not add detergent for this programme. START DELAY The “Start Delay” button allows the user to run the machine at his convenience, for example at night when electricity is cheaper. • Select programme, temperature and options. • Press the “Start Delay” button several times to select the delay time by 1 to 19 hours; • Press the “Start/Pause” button. The indicator light of the “Start/Pause” button lights up and the lamp of the “Start Delay” button flashes. • The time delay indication disappears when the programme starts and is replaced by the remaining time. • The number of hours preselected can be reduced later by pressing the “Start Delay” button again. [. . . ] • This function is particularly useful if you want to postpone spinning to a later time, or if you want to drain only. PAUSE/INTERRUPT A PROGRAMME If, for any reason, you wish to interrupt the programme for a certain time and continue it later: 1. Press the “Start/Pause” button. After the desired pause, press again on the “Start/Pause” button. CANCEL PROGRAMME 1. Set the programme selector to “Drain”. [. . . ]