User manual WHIRLPOOL AWZ 3415 INSTRUCTION FOR USE

[. . . ] Clean the filter at the end of every cycle. Completes drying or dries single items. (Suitable for all fabrics) PROGRAMME SEQUENCE INDICATORS Drying The programme sequence Airing indicator lamps show the status or the progress of the drying cycle. End Gentle and Rapid cannot be selected together. [. . . ] Check that all fastenings are closed and that pockets are empty. Place laundry loosely in the drum to make sure it doesn’t become tangled. Sort laundry as follows: A) By care symbols (on the collar or inside seam): Suitable for tumble drying Tumble drying with reduced drying intensity only Do not tumble dry B) By amount and thickness/weight Whenever the load to be dried exceeds dryer capacity, separate laundry according to weight (e. g. C) By type of fabrics Cotton/linen: Towels, cotton jersey, bed and table linen made of cotton or linen. Synthetics/Easy Care: Blouses, shirts, overalls, etc. made of polyester or polyamide, as well as cotton/synthetic mixes. D) By drying level • Sort into: iron dry, cupboard dry, etc. Do not tumble dry: Woollens, silk, nylon stockings, delicate embroidery, fabrics with metallic decorations, bulky items such as sleeping bags, etc. Important: only use specific indicated dryersafe additives and rinse items that have been treated with stain remover thoroughly in plenty of water before drying. Please specify: • The nature of the fault. • The service code (the number after the word Service on the adhesive rating plate) on the right-hand side when the door is open. • Your full address and phone number. • STARTING AND COMPLETING A PROGRAMME 1. Having selected the desired programme and options, press the Start button. If the laundry is not removed at the end of the drying cycle, an automatic anti-crease cycle will operate for maximum 60 min. The drum rotates at regular intervals, preventing the laundry from creasing. On completion of the programme, set the programme selector knob to position “0”. The dryer indicator lamp “Start/Pause” switches off. CHANGING A PROGRAMME When changing the programme during the drying cycle, the dryer stops. [. . . ] CHANGING A PROGRAMME When changing the programme during the drying cycle, the dryer stops. The indicator lamp of the Start/Pause flashes. To operate the new programme, press the Start/ Pause button again. [. . . ]