User manual WHIRLPOOL AWZ 412 PROGRAM CHART

[. . . ] Normally soiled bed linen, table linen and underwear, towels, shirts etc. Programme for treating laundry with starch and/or softener. The programme ends with an intensive spin cycle. Alternative method for unloading laundry earlier. [. . . ] In this case do not open the door: because hot water could come out of the door. CHANGING THE SELECTED PROGRAMME To change a programme when a cycle has already begun: 1. Switch off the appliance by pressing the “ON/OFF” button. Start the programme by pressing the “ON/OFF” button. INTERRUPTING THE CURRENT PROGRAMME To interrupt the selected programme and continue it at a later time: 1. After the desired interval has passed, press the “ON/OFF” button again. At the end of the programme the programme selector moves to the “Stop” position. To unload the machine wait for the door to release (approx. Switch off the appliance, open the door and unload the washing. Close the water tap and leave the door ajar to allow the drum to dry out. Load the machine according to the maximum drying load table. The drying function can only be used for cotton and synthetic programmes (not wool) and starts when the knob reaches the programme stop mark. It is important that the laundry has been spun and was washed with water. 2. When the spin cycle is finished the programme selector moves to “Stop”. Select a drying time based on the type of fabric (cotton/synthetic), amount of laundry and desired final results (iron/cupboard dry), using the “Drying Time” knob. Turn on the water tap, check the drain hose, use the “ON/OFF” button to turn on (the indicator light goes on). SETTING THE WASHING/DRYING CYCLE IN SEQUENCE 1. The sequential washing and drying function can only be used for energy-saving and synthetic programmes (not wool) and starts when the knob reaches the programme stop mark. Load the washer-dryer (according to the max. drying load table) and close the door 3. Select a drying time based on the type of fabric (cotton/synthetic), amount of laundry and desired final results (iron/cupboard dry), using the “Drying Time” knob. Set the “Washing Programme” knob to the desired programme 6. [. . . ] The indicator light comes on, indicating that the washer-dryer is on. SELECT THE DESIRED OPTIONS “Dryer half load” button (depending on model) “Intensive Rinse” button (depending on model) • The quantity of water duration of the rinse cycle are increased. • This option is especially recommended in areas with extremely soft water, for baby linen and linen belonging to skin allergy sufferers. button “Rinse and Hold” (depending on model) only for synthetic and wool programmes • The laundry remains in the final rinse water without progressing to the final spin cycle to avoid creasing and prevent colours from running. [. . . ]