User manual WHIRLPOOL AZA-HP 8040 PROGRAM CHART

[. . . ] A fast blinking lamp indicates a wrong selection is made (incompatible options). Press the button again to cancel the option. The drying programme is started by pressing the “Start (Pause)” button. Changing programme selection: If the programme selected is changed during drying, the dryer stops. [. . . ]  Has the cycle been interrupted (door opening, full water container)? Was the inserted laundry too wet (washing machine spin speed less than 1000 rpm)? Is the lint filter dirty (filter indicator light on)? Is the heat exchanger dirty (for more information, refer to the Instructions for use)? Is the “End” and “Anticrease” indicator lamp lighting up?The drying cycle is complete and the laundry can be taken out.  If the drying result does not meet your expectation, select a more dry programme or use the dryness adjustment option (if available) to optimize the drying result.        Is the plug properly inserted into the mains electricity socket?Has the “Start (Pause)” button been pressed?Has the start delay option been selected? Has the water container been inserted correctly? Is the heat exchanger clean and inserted correctly? Has the heat exchanger been inserted correctly? Have all lint on the heat exchanger seal and the door seal been wiped away? Has the water container been inserted correctly? If the direct drain connection is used, is it tight? Is the dryer leveled? The dryer does not operate (after a power failure, always press the “Start (Pause)” button) Filter, water container indicator lamp on Water droplets underneath the dryer . . . you want to care of and clean your dryer: Clean the filter at the end of every cycle  Brush lint using a soft brush or your fingertips.  Pull the handle to remove the water container.  Replace the water container when empty by pushing it completely back into place.  Clean the bottom filter under running water.  Clean the heat exchanger housing (for further information see chapter “Cleaning the heat exchanger” in the Instructions for use).  See the Instruction for use for further information how to clean the bottom filter. Empty the water container at the end of every drying cycle Clean the bottom filter every fifth cycle 3  FAILURE CODES In case of a malfunction of the dryer, one the following failure codes could be displayed. [. . . ] The function has to be dea Ad dditional reve erse Wit this option the drum will turn during the th e dry ying cycle more often against th main he turning direction th in a normal cycle. han f This will improve tthe evenness of laundry ying. dry Dry time a adjustment Turn the programme selec knob to ctor me” “Drying Tim position. the Press the b button “Drying time” to select t t duration of cycle in ten min nutes steps up t to 90 minutes. Gentle Selecting th option will re his educe the drying g temperature e. [. . . ]