User manual WHIRLPOOL AZA-HP 9682 INSTRUCTION FOR USE

[. . . ] • Keep the instruction for use and the programme chart. If you pass on the dryer to another person, also give him/her the instructions for use and the programme chart. • The manufacturer declines all liability for damage to property or injury to persons or animals due to noncompliance with the directions given in this instruction for use. Removing the packaging and check • After unpacking, make sure that the dryer is undamaged. [. . . ] EC Declaration of Conformity • This dryer has been designed, constructed and distributed in compliance with the safety requirements of EC Directives: • 2006/95/EC Low Voltage Directive. • 2004/108/EC Electromagnetic Compatibility Directive. • Oil-affected item can ignite spontaneously, especially when exposed to heat sources such as in a tumble dryer. The items become warm, causing an oxidation reaction in the oil. If the heat cannot escape, the item can become hot enough to catch fire. Piling, stacking or storing oilaffected item can prevent heat from escaping and so create a fire hazard. • Do not tumble dry unwashed items in the tumble dryer. • Ensure that the appliance is maintained as shown in the chapter “Maintenance and cleaning”. • Ensure that the appliance is installed per the description above. • Items that have been soiled with substances such as cooking oil, acetone, alcohol, petrol, kerosene, spot removers, turpentine, waxes and wax removers must be washed in hot water with an extra amount of detergent before being dried in the tumble dryer. • Do not use flammable cleaning agents. • Do not use the tumble dryer if chemicals have been used for cleaning. • Clean the bottom filter after every fifth drying cycle. • Place your dryer in a room with a temperature between 15° C and 20° C. In case of higher temperature, ventilate the room, e. g. • Always select the correct programme/ drying time for the load in order to obtain the desired drying results. • Select the gentle option only with small loads. 6 ELECTRICAL CONNECTION 1) For Great Britain only Warning - this appliance must be earthed Fuse replacement If the mains lead of this appliance is fitted with a BS 1 363A 13amp fused plug, to change a fuse in this type of plug use an A. S. T. A. approved fuse to BS 1 362 type and proceed as follows: 1. Fit replacement 13A fuse into fuse cover. Important: The fuse cover must be reinstalled when changing a fuse and if the fuse cover is lost, plug must not be used until a correct replacement is installed. Correct replacements are identified by the color insert or the color embossed in words on the base of the plug. Replacement fuse covers are available from your local electrical store. 2) For the Republic of Ireland only The information given in respect of Great Britain will frequently apply, but a third type of plug and socket is also used, the 2-pin, side earth type. 3) Socket outlet / plug (valid for both countries) If the fitted plug is not suitable for your socket outlet, please contact Whirlpool Service for further instruction. [. . . ] If the failure reoccurs, please call the After-Sales Service. F07 Turn the dryer OFF and unplug it. Make sure that the room temperature is between 5°C and 35°C. Unload approximately one half of the laundry from the dryer. If the failure reoccurs, please call the After-Sales Service. F10 – F24 Turn the dryer OFF and unplug it. [. . . ]